Rust Car Protection Corrosion Control Module Auto Rust Warrior.new . Electronic on 2040-parts.com
North York, Ontario, CA
STOP RUST BEFORE IT STARTS
Rust shortens the life of your vehicle & ruins its appearance, greatly reducing its resale value. The simple truth is that vehicles rust. In fact, they start rusting from the moment the steel is made. Fin Corrosion Control Rust Module forms a permanent barrier between the metal panels of the vehicle and the elements of nature to prevent corrosion.
Many people believe that road salt is the most common cause of vehicle rust. It certainly helps promote corrosion but the number one cause of vehicle rust is condensation. Moisture creeps into your vehicle’s seams and crevasses where this condensation acts as a conductor to promote rust. “Electrolysis” is another major contributor to vehicle rust whereby different types of metal on a vehicle actually generate an electrical current that actually accelerates corrosion! Protect your investment.
The Enemy: Condensation, Freezing Water, Electrochemical Corrosion, Humidity, Spot Welding, Road Salt
This module is a new environmental approach to winning the war on rust. It's a microprocessor that generates a repetitive pulsing surface current which reduces the oxidation of metal. The current is distributed to both sides of the car's sheet metal panels, including the floorboards and above the window line. Extra areas that conventional products cannot reach, such as the roof and inseams, are also protected with this method. Scientific studies show that the Corrosion Control Module can reduce the rate of corrosion by up to 99.7%.
ATV'S, RV'S, boats and even hybrid vehicles.
Specifications:
Input Voltage: 12 Volt DC.
Ground: (-) Negative.
Current Draw: 0.3 mAmp
Impressed current 2Hz Frequency speed of electrons pumping.
Anode Composition:
"Auto Rust Warrior™ Capsules" non-sacrificial.
Command Module Size:
Anode: 50mm X 50 mm.
Weight: 230g.
The Auto Rust Warrior ® Rust Control module attaches to your regular car battery and draws about as much current as your cars clock. Over every 8 second cycle it emits a surge of "free" electrons throughout your vehicle to the very places your car has lost its protective paint and coatings (through stone chips, scratches, and abrasions) and "shields" these exposed areas from harm. The charge is too small to be noticed; however the free electrons interfere with the rusting process and retard rust and corrosion significantly.
Auto Rust Warrior is one of a kind and substantially extends auto body life through “Electrolyte capacities discharge oxidation interference” (ECDOI), a form of impressed current technology.
The Auto Rust Warrior ® Rust Control module.
- 1 Built-in conductive pad
- 1 Gray wire for body
- 2 flashing LED’s Red & Blue that indicate the product is functioning correctly.
- 1 Over voltage safety Fuse.
- 1 Black –ve Battery wire
- 1 Read+ve Battery wire
- 1 Installation instruction
- 1 Packing bag along need full connectors and screws.
The Auto Rust Warrior ® module is based on the principle that corrosion is an electrochemical reaction, oxidization, which can be controlled electronically. The rusting process begins with the loss of negative electrons that permit iron and oxygen to combine to form rust. The faster iron combines with oxygen, the faster the metal deteriorates. The metal body of a vehicle has a more positive electrical charge at the area where rust is occurring because electrons are robbed.
The electronic corrosion control process introduces a negative surface charge to the metal body which polarizes the microscopic layers of electrical charges that occur along a corroding metal surface.
In essence the
module makes it very difficult for the opposite charges of iron and oxygen to connect. Since they are hindered by polarized layers of charges, the negative surface charge - and its corresponding polarized charge layers - reduces the rate of which the iron and oxygen combine, slowing down the corrosion process. In other words, the Electronic Corrosion Control module makes it very difficult for iron and oxygen to combine to form rust.
Protect Your Automobile Body From Rust & Corrosion.
These electrons making barrier in between atmosphare & automobile body.
Zinc from Mattel + Oxide from Atmosphare = Rust Creation. If you makes a 2HZ frequency signal barrier for stoping the natural reaction so it will be safe by Rust.
The results is STOP RUST & Prolong you automobile body life
Other for Sale
Mitsubishi lancer evolution 2008-2012 front license plate bracket(US $25.00)
Mercedes w201 190d 300d engine cylinder head gasket set reinz 602 010 66 20 new(US $55.00)
Cadillac 1931 raiator cap repro (US $52.00)
Bmw e46 323i 325i 328i 330i headlight lenses lh and rh set(US $9.99)
Mercedes benz c220 c230 c280 c36 amg e300 e320 e420 power antenna replacement(US $79.00)
Hyundai oem 695102h001 quarter panel-fuel door(US $51.88)
Lamborghini Reventon Roadster – First customer car
Tue, 01 Dec 2009The first Lamborghini Reventon Roadster has been delivered to Switzerland The Lamborghini Reventon Roadster has been a bit of a saga here at Cars UK Towers this year. We broke the news that Lamborghini were planning a roofless version of the Reventon Coupe back in March, and apart from the fact that no one believed our ‘Scoop’ – and we had Lamborghini on the phone asking us to retract the story – we were sure the information we had was real. So it was more than a little gratifying when were able to report that Lamborghini were doing a private reveal of the Reventon Roadster in July and finally the Lamborghini Reventon Roadster was launched at the Frankfurt Motor Show in September.
Nissan Juke-R races Ferrari 458, Lamborghini Gallardo & Mercedes SLS AMG
Sat, 21 Jan 2012Nissan Juke-R takes on Supercars in Dubai The Juke with the heart of a GT-R – the Nissan Juke-R – takes on a Ferrari 458, Lamborghini Gallardo and Mercedes SLS AMG in Dubai. We’re not entirely sure how the Nissan Juke-R – the love child of a Juke and a GT-R – ended up in Dubai pitted in a race against a selection of the world’s best supercars – but it did. Let’s call it serendipity.
2014 (or is it 2015?) Ford Mondeo to launch in UK & Europe late 2014
Fri, 31 Jan 2014The new Ford Mondeo will now arrive in the UK in late 2014 The story of the new Ford Mondeo for the UK Europe (which should have been the 2013 Mondeo but will end up as the 2014 or 2015 Mondeo) has been a bit tortuous. Despite the new Mondeo being on sale in the US as the Ford Fusion since summer 2012, and in China since summer 2013 (and the reveal of the production version of the Mondeo over two years ago and a set of new Mondeo photos too), Ford’s decision to shut up shop at Genk in Belgium – the Mondeo’s traditional manufacturing plant – meant there was no way to give Europe the new Mondeo. So we’ve had to wait for Ford to sort out production lines in Valencia to build the new Mondeo but now, according to Mark Ovenden – Ford’s UK boss – the new Mondeo will arrive in the third quarter of 2014 in the UK and Europe.
