(1960's-1970's) Invader Wheel / Rim (harley / Triumph) (chopper / Bobber) on 2040-parts.com

HERE IS A 16" INCH INVADER MAG WHEEL / RIM. THIS IS AN ORIGINAL INVADER WHEEL / RIM FROM THE 1960'S OR 1970'S.  THIS WHEEL CAN BE USED AS A FRONT WHEEL OR REAR WHEEL ON HARLEY DAVIDSON MOTORCYCLES. AS A REAR WHEEL, IT CAN BE USED WITH A DISC BRAKE ON ONE SIDE AND A (CHAIN DRIVE), (BELT DRIVE) ON THE OTHER SIDE. ALSO A COMBINATION DRIVE / BRAKE PULLEY KNOWN AS A SPROTOR WILL WORK, YOU CAN JUST PUT DECORATIVE BOLTS ON THE OTHER SIDE TO COVER UP THE 5 MOUNTING HOLES. AS A FRONT WHEEL, IT CAN BE USED WITH SINGLE DISC OR DUAL DISC BRAKES. IF YOU USE IT AS A FRONT SINGLE DISC WHEEL, YOU CAN JUST PUT DECORATIVE BOLTS ON THE OTHER SIDE TO COVER UP THE 5 MOUNTING HOLES. WE TOOK THIS WHEEL OFF THE REAR OF A CUSTOMIZED PANHEAD MOTORCYCLE THAT HAD A DISC BRAKE ON ONE SIDE AND A BELT DRIVE ON THE OTHER SIDE. WHEN WE TOOK THE WHEEL OFF, WE NOTICED ONE SPOKE AREA HAD A CRACK ON EACH SIDE OF THE RIM, WHEN WE TOOK THE TIRE OFF, WE NOTICED THAT IT HAD LITTLE WELDS ON THE INSIDE OF THE RIM. THE GUY HAD THE TIRE MOUNTED ON THE RIM USING A TIRE TUBE INSIDE AND IT SEEMED TO WORK FINE FOR HIM, YOU CAN REWELD IT AND FIX IT TO RUN A TUBELESS TIRE, OR YOU CAN JUST USE A TIRE WITH A TIRE TUBE AGAIN. THE RIM HAD SOME RUST SPOTS ON IT, SO WE GAVE THE RIM A QUICK HANDHELD SAND BLAST JOB AND SPRAYED A COUPLE COATS OF PAINT ON IT JUST TO CLEAN IT UP A LITTLE. THIS WHEEL IS MADE FOR HARLEY DAVIDSON MOTORCYCLES, BUT WITH A LITTLE MACHINING AND SOME NEW HOLES DRILLED OUT, IT CAN BE MADE TO FIT JUST ABOUT ANY MOTORCYCLE YOU WANT, (AMERICAN / BRITISH / JAPANESE, ECT). I'M OFFERING FREE SHIPPING WITH INSURANCE TO ANY BUYER IN THE U.S., A BUYER OUTSIDE THE U.S. WILL PAY EXACT SHIPPING AND INSURANCE FEES. DUE TO HIGH SHIPPING PRICES AND LOW PROFIT MARGINS, I CAN'T AFFORD TO ACCEPT RETURNS, SO PLEASE MAKE SURE THAT THIS IS THE PART YOU NEED OR WANT BEFORE BUYING IT. THANK YOU