(2) Moser Axle Direct Fit C-clip Rear 1541h Steel 31-spline Ford Mustang 8.8 In on 2040-parts.com
Tallmadge, OH, US
Axle Parts for Sale
- Axle shafts 12 bolt 8.875 chevy gm 70 camaro chevelle posi el camino c-clip(US $89.00)
- Pontiac 64 65 66 bolt in axles 10 bolt 8.2 a-body gm 442 skylark gto firebird(US $135.00)
- Strange axle retaining plate a1018(US $11.97)
- Moser engineering replacement alloy axle shaft a28-64must(US $369.97)
- Bmw 318i 325e 325 325es 325i 325is genuine washer fluid reservoir - windshield(US $88.45)
- Bmw x5 2000 2001 usa industries / empi axle shaft assembly (output shaft)(US $121.59)
Porsche Cajun: the 2-door coupe crossover
Tue, 12 Oct 2010The Porsche Cajun Coupe Crossover It’s only a week or two since we finally discovered for certain that Porsche will be building an SUV / Crossover based on the Audi Q5. And we also discovered that instead of being the Porsche Roxster – which was always a bit of joke name – Porsche’s trendy crossover would be the Porsche Cajun. And yes, we fully expect the Porsche Chilli and the Porsche Jalapeno to join in at some point in the future.
Caterham Seven (2006): first official pictures
Tue, 24 Oct 2006By Ollie Compton First Official Pictures 24 October 2006 12:47 Caterham Seven: the lowdown Caterham has kicked out the K-series, replacing it with a tuned 1.6-litre Ford engine for the next generation Seven sports car. The Sigma engine – used in the Fiesta and Focus – is available with two outputs: 125bhp in the Roadsport (pictured), or 140bhp in Superlight trim. A third engine with around 160bhp will follow in spring 2007.
Old is new again: Will a floor-hinged throttle pedal be in your future?
Thu, 02 Sep 2010If you think that every little nut, bolt, switch, gear or widget in your new car wasn't scrutinized by a team of highly educated, overworked car geeks (read: engineers), think again. A couple of recent conversations with automotive engineers confirmed that virtually nothing that goes into a car today is taken for granted. During the recent Pebble Beach weekend, I had the pleasure of spending time with an engineer for Jaguar, and the subject turned to materials used for various switches in the cabin.