Atlas 2 Post Auto Lift 9,000 Lb. Capacity Car Vehicle Truck Lift Baseplate New on 2040-parts.com

Atlas 9KBP 9,000 LB.
Base-Plate 2 Post Lift

This auction is for one Atlas 9KBP Base-Plate 2 Post Lift.

Product Code: XH-9KBP

If you would like to receive a shipping quote, please call
our location nearest you.


Description:
The Atlas 9KBP is a base-plate two-post lift designed for low ceiling garages.
The total column height of 111 ½" (9 feet 3 ½ inches) allows this lift to be
installed in almost any professional or home garage with a ceiling as low as
9 feet 6 inches.

Symmetric Columns and Arms:
The Atlas 9KBP includes a symmetric column configuration to offer the widest
possible Drive Thru. The Atlas 9KBP baseplate above ground lift has
symmetric arms to allow easy access to both sides of the vehicle. The Atlas
9KBP also includes two additional lifting pads that offer an infinite amount of
lifting points for the rear lift arms.

Chain-Over-Roller Cylinder Configuration:
The Atlas 9KBP has the chain-over-roller cylinder configuration.

There are two popular hydraulic cylinder configurations used in two post
electric/hydraulic above ground lifts:

Greg Smith Equipment sells above ground lifts that incorporate both the direct
drive cylinder configuration and the chain-over-roller cylinder configuration.

The base plate two post above ground lift implements the chain-over-roller configuration. This is the only hydraulic cylinder system that is possible in the base plate lift. The base plate two post above ground is designed for "low ceilings". The direct drive hydraulic cylinder configuration cannot be used in the base plate lift because the hydraulic cylinder would extend above the 9' 3" column when the lift arms were raised to the maximum height.

The "overhead" two post above ground lift may incorporate either the direct drive hydraulic cylinder or the chain-over-roller hydraulic cylinder.

Electrical Requirement:
The electric motor for the power unit requires 220 Volt (single phase) 60 Hz. We recommend using at least a 10 gauge (grounded) wire from the electrical panel. The power unit has a short pigtail (no plug) that can be wired to either a quick disconnect box (mounted on the lift column) or to a male/female plug combination. A 30 amp breaker is recommended.

Installation:
Most of our above ground lift customers install their own car lifts. The average time to install the Atlas 9KBP car lift is four hours. We provide detailed installation instructions with all of our two post above ground lifts and our four post above ground lifts.

Parts:
Greg Smith Equipment stocks a complete inventory of lift parts for all the lifts we sell. The lift parts and the above ground lifts are stocked at both our Indianapolis and Delaware locations. Certain Competitors do not stock the lifts they advertise and do not stock any of the lift parts or accessories.


Additional Features:

Symmetric Arms

Base plate Design

9,000 lb. capacity

Designed for low ceiling clearance - 9' 3 ½" columns

Free Truck Adapters

Mounting Hardware Included

Watch a Competitor's 10,000 LB. Two Post Lift FAIL INDUSTRY TESTING:
Cheap lifts are dangerous!

Questions? Please call any of our locations: 800.262.1950 (Indiana) 800.715.1950 (Delaware) 800.768.4104 (Georgia) 800.602.9928 (Arizona) 800-360-0053 (New Hampshire) 800-305-5609 (Florida) 800-512-7611 (Texas)

Atlas 9KBP Specifications
Capacity	9,000 LB.
Lifting Time	Ask Your Salesperson
Overall Height	111 ½" (9' 3 ½")
Overall Floor Width	134 ½" (11' 2 ½")
Outside Column to Outside Column	124 7/8" (10' 4 7/8")
Maximum Lift Height	74 ½" (6' 2 ½")
Minimum Pad Height	4"
Base Plate Width	10 ¾"
Inside Column	110" (9' 2")
Drive Thru	101" (8' 5")
Column Size	7 1/4" x 11 1/8"
Column Thickness of Steel	5 gauge (.2", 5.08mm)
Cable Diameter	.375"
Base Of Lift	13 ½" x 18 ¼"
Motor/Electrical Requirement	2.5HP 220 volt single (1) phase. A 30 amp breaker is recommended.
Shipping Weight	1,400 LB.

Before buying, please consider the following:

• Everything we post on Ebay is either in stock or contains accurate info regarding exactly when it will be. In other words, we don't make you wait! In fact, we have perhaps the largest inventory of above ground vehicle lifts, tire changers, wheel balancers, and motorcycle lifts in the country!


• We are NOT just an Internet site. We have been a brick and mortar operation since 1982. If you get a chance, please come visit one of our huge equipment showrooms.


• We have some of the most knowledgeable professionals in the industry. When you call our office during normal business hours, you will speak to a live person immediately. We realize that everybody's time is important and we do not believe in answering machines during normal business hours. Our company was started long before the Internet became popular, and we still welcome the "old-fashioned" phone call as a way to assist our customers in their buying decision. Call one of our locations with any questions.

Parts
Greg Smith Equipment has a well staffed service department that is augmented by a huge parts department. Most Internet wheel service companies are not concerned with after the sale service. Greg Smith Equipment understands the need for expert technical advice, backed up by a fully stocked parts department.

Greg Smith Equipment knows that our products (no matter how well built) will eventually need parts. We believe that a complete parts inventory (and a well trained service department) is as important as a well stocked product warehouse.

Shipping
The Atlas 9KBP will be shipped by common carrier. It will arrive in an enclosed truck and the customer is responsible for unloading it with a forklift (or something similar to that). You will save money on shipping by having it delivered to a business address or trucking terminal. You can have it shipped to a residence, but please note that you will need to have the necessary equipment to unload it (a $30 additional charge will be added for residential delivery). If you do not have a business where we can ship it, another option is to have it shipped to a trucking terminal. At the terminal, the staff will be able to load the product on your trailer. The same shipping rates apply for business and terminal delivery. Applicable sales tax will be charged if shipped to an Indiana, Georgia, Arizona, Florida, or Texas address. There is NO SALES TAX IN DELAWARE OR NEW HAMPSHIRE. Call one of our locations to receive a shipping quote. We offer great freight rates!

Pick Up
The lift can also be picked up at our facilities. Applicable sales tax will be charged if picked up in Indiana, Georgia, Arizona, Florida, or Texas unless a valid tax exemption form is provided. There is NO SALES TAX IN DELAWARE OR NEW HAMPSHIRE.