Refurbished Injectors by
Injector Repair LLC
One Year Limited Warranty
(518) 956-0014
This is a set of eight (8) professionally refurbished and fully tested genuine 19 lb/hr OEM Bosch fuel injectors, Bosch # 0280155746, or for cross reference purposes, GB Remanufacturing # 852-12162.
This is a Flow Matched set.
The computerized fuel injector bench testing unit in the pictures above show one of the actual flow test results from this set of Bosch injectors - after servicing they flow matched at just at just 1 % ( awesome ) !! A flow matching set of injectors should all be flowing within 5% of each other for proper engine performance, power, smooth idling and smooth throttle response during acceleration.
These injectors have all new upper and lower o-rings, and most importantly, new internal microfilters installed. Why take a chance on untested used fuel injectors that may have crud filled internal filters, old hardened o-rings, or a bad coil ??
This set of injectors look good, but they do have normal cosmetic stains and scratches in the yellow plastic from being in prior service.
All of the injectors I sell are fully cleaned, back-flushed, lubricated, and flow tested. They are 100% ready to be put into service.
They are guaranteed to perform like new.
These are the newer Bosch generation III fuel injectors with the EV1 type connectors, and with the 4 hole fuel discharge for much better fuel atomization ( misting ) and better spray pattern, which allows for a more even and complete burn - this gives you significantly more power and better gas mileage for the same amount of fuel.
- 19 lb/hr, 200 cc/min at 43.5 psi ( 3 bar )
- Bosch Generation III
- 4 hole discharge
- EV1 Jetronic connector
- 16 + ohms ( approximate ) / High impedance
These Bosch design III injectors are a perfect Ford performance upgrade if you are looking for a high performance 19 lb / hr fuel injector. I put together a set of eight for doing an eight cylinder injector upgrade. I have more of these available, so if you need a set of four or six, give me a call and I can put a flow matched set together for you.
These are true 19 lb/hr flow rate injectors. These are a perfect replacement upgrade for all Ford '19 lb/hr ' yellow injectors that have an actual flow rate of only 18.25 lb/hr !! These injectors will give you more power when running at wide open throttle ( where the computer stops using the O2 sensor for air / fuel mixture control ie. open loop ), and will allow more fuel delivery under heavy load conditions like towing etc.
If you are going to use these for an injector upgrade, give me a call if you have any questions on their installation.
Outside of ebay I run a Fuel Injection Refurbishing business called Injector Repair LLC. Sending your own vehicles' injectors out to be refurbished, or buying a complete set of refurbished fuel injectors are great ways to save a ton of money vs. buying brand new injectors at $70 TO $150 FOR EACH NEW INJECTOR. Genuine OEM Fuel Injectors are designed to outlast your engine, and should last way more than 300,000 to 500,000 miles. They usually only fail to perform when they get clogged ( a bad side effect of ethanol, or a bad batch of contaminated gas ), or when the injectors internal coil winding fails ( happens, but rarely ). OEM injectors that are factory original are far superior in quality than the aftermarket injectors sold by the big name aftermarket suppliers. They may look the same, but they are definitely not the same quality as OE brands like Bosch, Delphi, Denso, IPT, JECS, Keihin, Rochester, Siemens Deka, and Weber. Aftermarket injectors are not manufactured to the strict tolerances that OEM injectors are, and the aftermarket injectors are made to just last longer than their year warranty.
Beware of buying a cheapo set of ' no name ' brand of fuel injectors !!
Each fuel injector we refurbish is;
- externally cleaned
- resistance checked
- parts ( including internal filter ) are removed
- the injectors are ultrasonically cleaned while being computer driven
- injectors are back-flushed
- Then the injectors parts are replaced with new high quality o-rings, plastic caps (when needed ), plastic spacers, and the internal injector microfilter.
- The set of injectors are then flow tested on a computerized fuel injector bench testing unit and evaluated for leak down, flow volume and spray pattern. In order to pass, the injectors have to not leak when closed under full pressure, and they have to have the proper spray pattern and the proper flow volume when tested under a number of different scenarios. They are subjected to multiple tests and are tested; At Static condition (wide Open), 3 millisecond pulse width, 6 millisecond pulse width, 12 millisecond pulse width, and are tested at various RPM.'s. These tests insure that the injectors are performing correctly under all conditions, and will detect a faulty injector coil that may have passed a resistance check.
This set performed excellent, and flow matched at just 1 % !!!!
We have a One Year Limited Warranty, with a 60 day no questions asked warranty policy; if you are not happy for any reason during the first 60 days, just send them back for a refund - and no restocking fee. You pay for return shipping. After 60 days we will either repair or replace any defective injector. Go to the Injector Repair LLC company website for warranty policy details.
Call us at (518) 956-0014 with any questions.