Find or Sell any Parts for Your Vehicle in USA

03 04 05 06 07 Ford F-250 Super Duty 6.0 Diesel Ficm Repair Service To Your Unit on 2040-parts.com

US $151.11
Location:

Winona, Minnesota, United States

Winona, Minnesota, United States
Condition:Remanufactured Warranty:Yes


 

YOU ARE NOT BUYING THE UNIT SHOWING, YOU NEED TO SEND YOURS INTO BE REPAIRED....

 

 

**********Please ignore the estimated shipping time that I have listed on this auction….! Due to Ebay’s new handling time policy it does not allow for the shipping time that it takes for you to ship it to me and for me to repair your unit and then they would penalizes me for appearing to have slow shipping/handling time(WHICH I DO NOT). So I have to enter a very ridiculous long handling time so I do not fall out of their parameters, so I can still be Trusted and Great seller also. My actual handling time for repairs are once I receive your item for repair it is a ONE DAY or the SAME DAY turn around and then I ship it back to you right away..! If you have any questions at all feel free to contact me at 507-429-4489.************

Thanks David

 

 

 

Is your Ford 6.0 Diesel Truck having any of the following problems?   If so then I’m here to get you back up and running again…

 

This module fails causing problems with your Truck, P0611 code , ,,,,,, like not to start or slow cold start and very poor fuel economy and power loss…if this is so, then your FICM (Fuel Injection Control Module) is more than likely bad and needs to be repaired…

I have identified the failure and can repair and upgrade your FICM with a permanent solution to your problem…

And this repair comes with a LIFETIME warranty…..

 

ALSO REMEMBER THAT THIS IS A REPAIR SERVICE TO YOUR UNIT… YOU MUST SEND YOU BAD FICM INTO ME TO BE REPAIRED AND THEN I SEND YOURS BACK TO YOU…..

 

PLEASE DO NOT SEND A FICM THAT HAS BEEN UNDER WATER OR THAT HAD SMOKE COMING FROM IT,,, WE WILL NOT REPAIR THEM,.

 

 

-*If you are not sure if this service is for you just CALL 507-429-4489.

 

·         THIS REPAIR SERVICE TO YOUR FICM WILL COVER THE FOLLOWING VECHICLES LISTED BELOW, Equipped with a International Module ,,,,

 

2003 to 2007 FOR F-250 SUPER DUTY 

 

How to test FICM to see if it is bad.........

 

On top of the FICM you will see small rectangular plate with 2 T20 torx screws.  Remove them and pull the plate off,,, YOU MUST ONLY TOUCH THE SCREW CLOSET TO THE DRIVER SIDE,  AND  BE VERY CAREFUL NOT TO TOUCH ANYTHING ELSE WITH YOUR METER LEAD…,    check that screw (DC Voltage) to battery ground, you should measure 45 volts or above , If the voltage measured is less than 45 volts then your FICM needs repair… 

 

 

    PLEASE KEEP IN MIND THAT SOME UNITS MAY NOT BE REPAIRBLE AND IF THAT IS THE CASE, I WILL REFUND YOUR MONEY AND SEND YOUR UNIT BACK TO YOU,,,,,,,,

 

 

 

This repair to your FICM does not require and programming to you unit…

 

 

 

 

  • What you have to do after winning this FICM REPAIR SERVICE..
  •  
  •  
  • Remove your defective FICM by disconnecting your battery.
  •  
  • TAKE YOUR DEFECTIVE FICM OFF OF THE VALVE COVER (driver’s side, must look like the one in the picture) AND SEND IT TO ME WITH PAYMENT OR COPY OF THE PAYPAL TRANSACTION..

 

            The FICM is held down by 4 bolts, so remove them and then disconnect the 3 connectors that are plugged into the FICM……

  •  Pack your FICM in bubble wrap and put in a good box,,,,,, NO peanut packing stuff…..

The day I get your FICM it will be repaired and tested and shipped back out the next business day by 2nd day ups, 

 

By having me repair your unit you will be saving $100’s of dollars from your local Ford Dealer,,,  Ford dealers are asking from $650 to 900 to install and program another unit and that will go bad also over a matter of time….   So you make a choice,,, save or spend….

 

          You pay for shipping your FICM to me …..

 

 

        SEND YOUR DEFECTIVE FICM TO:

  • DAVID RUBERG
  • 123 W. SARNIA ST.
  • WINONA, MN 55987

 

 

What you need to know….
-I repair your FICM WITH my HIGH REPAIR STANDARDS, that is why I can put a LIFETIME WARRANTY on it AND nobody else on eBay can do this.
-They are having a lot of problem with this FICM for the VECHICLES above, how do I know. Because over the past 7 years I have repaired over 2,300 of these FICM for people like you.

A little about me…..
I have 25 years in the Automotive Electronic field. I have repaired over 2,300 of these FICM for people like you. I stand behind my work so you can purchase this FICM REPAIR SERVICE WITH Confidence. Happy eBay bidding I hope you win it.

Contact and Shipping information….
-Shipping: Within the 50 U.S. states (UPS ground, or USPS)
-Insurance: The first $100 is free if you want more than that let me know.

 

 

 

Other for Sale

Listen again to Autodesk VRED Professional for High End Image Production webinar

Tue, 25 Jun 2013

Autodesk presented its latest webinar, ‘VRED Professional for High End Image Production webinar' on 24 June. VRED Professional 2014 software helps users to create high-end visualizations and virtual prototypes in the automotive development process and CGI production. Visualization experts, marketers, and CGI artists can use the full power of its ray tracing render engine to produce realistic and compelling imagery that depict accurate physical characteristics of materials and lights in real time.

One Lap of the Web: Classic Mustang road trip, V4 engines and the flaming Viper

Tue, 22 Oct 2013

-- In honor of the Ford Mustang and it's upcoming 50th anniversary, Hagerty is taking a cross-country trip in a 1964.5 Mustang coupe. The car is solid but not exactly show-worthy, plus it has a three-speed manual transmission. In other words, all the ingredients for a really long road trip.

Flintoff spared ban for speeding

Fri, 29 Aug 2014

ANDREW 'Freddie' Flintoff has escaped a driving ban for speeding in his Bentley after arguing "exceptional hardship" to magistrates. Flintoff, 36, was already on nine points for speeding and in danger of an automatic ban with another three points after admitting being behind the wheel when flashed by a camera doing 87mph on the M6, near Linstock, Cumbria on January 28 this year, Carlisle Magistrates' Court heard. But JPs accepted a ban would amount to exceptional hardship because of the effect on others who rely on his extensive charity work and the privacy of his three children.