0582346 Complete Magneto Plate Assy Incs O582020 O582023 35hp Evinrude Johnson on 2040-parts.com
Putney, London, United Kingdom
|
This is a new part - never installed on an engine - but it is old stock so just a bit dusty The armature plate that this is mounted on is 0582020 and is also factory printed with the number o582023 All complete and ready to fit As far as we can ascertain this was only fitted to the 1982 35hp's May have been on other similar engines the same era - you must check your parts list before ordering Chas Newens Marine Co Ltd The Boat House Embankment Putney SW15 1LB 02087884587 Opening hours are Mon-Sat
09.00 to 18.00 hrs Closed Sundays |
Impellers & Components for Sale
Seadoo 657 717 720 sea doo gts gs hx gti xp spx 1993-2001 exhaust gasket kit(US $12.55)
New sea-doo through hull fitting thru 292000075 gt sp gts gtx xp spi gtx xpi hx(US $40.00)
New oem seadoo speedometer wire speed sensor 278001668 1998-2004 xp, gti, gts(US $150.00)
2 new oem sea-doo venturi bushing gtx speedster challenger gti wake 293900001(US $8.00)
Seadoo transmission driveshaft 1999-2007 xp ltd xp 3d di xpdi 947 951(US $85.00)
1 new oem seadoo pto rubber boot 96-97 gtx 98-02 gtx rfi 98-02 gtx rfi 95-96 xp(US $17.00)
Mercedes & Mauro Calo set new world drifting record (video)
Mon, 20 Jun 2011Mercedes C63 - tyres alight We put you on notice last week that a Mercedes C63 AMG – being driven by Mauro Calo – was going to attempt a new world drifting record at MB World. Well, as we suspected, they had little trouble claiming the record. Mauro Calo is very familiar with Mercedes and with the track at MB World.
Porsche 911 GT3 RS 4.0 gets official +video
Thu, 28 Apr 2011Porsche 911 GT3 RS 4.0 - this time from Stuttgart The Porsche 911 GT3 RS 4.0 has been rumoured for a while, and yesterday we finally had so much information on the Porsche 911 RSR for the road that we ran the story. We had a set of photos of the 911 GT3 RS 4.0, and just about all the specs you’re likely to need, so there seemed no point in not publishing what we had. But, as we said yesterday, that amount of information on a yet-to-be revealed car would force Porsche’s hand.
Dodge Hornet 'could be partnered with Nissan'
Thu, 12 Jun 2008By Dimitri Pesin Motor Industry 12 June 2008 17:47 Chrysler could work with Nissan to produce its long-awaited, super-butch supermini the Dodge Hornet, CAR Online has learned. The concept car was first shown back in 2006 and is being readied for a launch in 2010. Chrysler had been negotiating with Chinese car maker Chery, but according to CAR's sources it could now be developed with Nissan.