Find or Sell any Parts for Your Vehicle in USA

1967 1968 1969 1970 Cadillac Trunk Cable Retraction Air Cylinder Set Original on 2040-parts.com

US $149.99
Location:

Holiday, Florida, United States

Holiday, Florida, United States
Condition:Used Placement on Vehicle:Rear Warranty:No

1967 1968 1969 1970 CADILLAC TRUNK CABLE SET WITH AIR RETRACTION CYLINDER PULLER ORIGINAL

TAKEN FROM 1969 CADILLAC ELDORADO - THE ORIGINAL TRUNK CABLE SET COMPRISING : THE AIR RETRACTION CYLINDER - CABLE - EYE LOOP FITTING ALREADY ATTACHED TO CABLE FOR INSERTION INTO THE LATCH ASSEMBLY OF YOUR EXISTING CADILLAC'S TRUNK LOCKING LATCH - THE BENT NAIL HEAD ATTACHMENT MEMBER THAT NEEDS TO BE DRILLED AND CRIMPED ONTO CABLE AFTER PASSING THE CABLE THROUGH THE SPIRAL METAL FLEX TUBE - THE AIR CYLINDER ATTACHMENT MEMBER CLIP FOR RETAINING THE BENT NAIL ATTACHMENT MEMBER ONTO THE RETRACTION CYLINDER.

I HAVE ALSO INCLUDED THE SPIRAL METAL FLEX TUBE IN CASE YOU NEED IT. AS YOU SEE IT IS SNAPPED IN HALF,... BUT SINCE THIS TUBE NEEDS TO BE PERMANENTLY FIXED TO THE TRUNK BED WITH RHINO-LINER OR EPOXY,.. IT SHOULD NOT STOP THIS FLEX TUBE FROM WORKING SINCE IT WILL BE CONSTRAINED IN PLACE ONCE YOU PUT THE 2 SNAPPED ENDS NEXT TO EACH OTHER WHEN YOU SET THE FLEX TUBE IN THE EPOXY OR RHINO-LINER TO SETUP PERMANENTLY IN ITS FINAL FIXED POSITION.

MOST FOLKS WILL JUST NEED THE CABLE OR THE AIR CYLINDER,.. USUALLY THE OLD FLEX CABLE IS ALREADY IN THE TRUNK AND SOMEONE JUST NEEDS THE CABLE OR THE AIR CYLINDER OR JUST ONE OF THE ATTACHMENT MEMBERS FOR THE CABLE.

I AM ALSO LISTING SEPARATELY THE FOLLOWING INDIVIDUAL ITEMS FROM THE TRUNK CABLE ASSEMBLY:

1) - THE AIR RETRACTION CYLINDER - $99.99

2) - CABLE ONLY (NEW AND CUT TO PROPER LENGTH) $49.99 (NOT SHOWN IN PHOTOS SINCE ITS JUST NEW CABLE CUT TO THE CORRECT LENGTH)

3) - CABLE WITH EYE LOOP FITTING ALREADY ATTACHED TO ONE END OF CABLE $69.99 ( EYE-LOOP FITTING INSERTS INTO THE LATCH ASSEMBLY OF YOUR EXISTING TRUNK''S LOCKING LATCH )

4) - THE BENT NAIL HEAD ATTACHMENT MEMBER $19.99 ( NEEDS TO BE 1/16" DRILLED AND USED TO CRIMPED ONTO CABLE AFTER PASSING THE CABLE THROUGH THE SPIRAL METAL FLEX TUBE)

5) - THE AIR CYLINDER ATTACHMENT MEMBER RETAINER CLIP $19.99 (FOR RETAINING THE BENT NAIL ATTACHMENT MEMBER ONTO THE RETRACTION AIR CYLINDER)

BELOW NOT INCLUDED

6) - SPIRAL FLEX METAL SHEATH TUBE $49.99 ( 2 PIECE METAL SPIRAL TUBE SNAPPED IN HALF FOR PASSING CABLE THROUGH & SECURING TO TRUNK FLOOR)

Opel / Vauxhall Astra revealed

Wed, 13 May 2009

New Vauxhall / Opel Astra revealed ahead of a launch at the Frankfurt Motor Show in September The Astra has been with us for 30 years, and this is the sixth generation to hit the showrooms. And it looks to be the best yet (as you would hope), with a cohesive style and loads of design cues taken from Vauxhall’s Insignia. This new Astra is built on the same platform as the much heralded Vauxhall Ampera (the Electric Car that will be the salvation of GM – once the technology is sorted) and as such offers a bigger wheelbase (up by 71mm) on a 4.4 meter (14′ 4″) body, with a wider track, which should make the Astra a better drive.

Buick Encore video gives us a proper look at the Opel / Vauxhall Mokka

Fri, 20 Jan 2012

Buick Encore video previews the new Vauxhall Mokka The Vauxhall/Opel Mokka may not arrive until Geneva 2012, but we get a good look at what’s on offer in this Buick Encore video. The whole ‘World Car’ phenomenon that’s sprung out of the mire of the financial woes of the US car industry does lead to a few anomalies. Like the Buick Encore being revealed in the States whilst Europe has only had a couple of photos of the Opel / Vauxhall Mokka ahead of its debut at the 2012 Geneva Motor Show in March.

2015 Ford Mustang spotted testing in Detroit

Thu, 31 Oct 2013

The 2015 Ford Mustang is nearing production. The proof is on Detroit's Woodward Avenue, where one of our readers spotted this mule in full camouflage. Upcoming cars usually don't hit the well-traveled strip of asphalt unless they're almost ready for the public.