1978-83 Chevy Malibu Station Wagon Drive Shaft 350 Small Block V-8 W/350 Turbo on 2040-parts.com

I was told this drive shaft was from a fourth generation Chevrolet Chevy Malibu station wagon stationwagon and that it would fit 1978, 1979, 1980, 1981, 1982, 1983 cars with a small block chevy engine that has a turbo 350 transmission and I think a 10-bolt rearend. U-joints look good and shaft is straight with no dents. Rear joint has grease zerk, sorry I don't remember if the front one does or not.
If this drive shaft is too long or too short, but it has the correct ends for your application, it may be easier and cheaper to buy this shaft and have the tube length shortened or lengthened.

Anyway, here's her dimensions:
1. total length: measure with drive shaft vertical on floor, from floor to tip of slip yoke is approximately 55 and 3/4 inches long.
2. from center of one u-joint to center of the other is approximately 49 and 1/2 inches.
3. the slip yoke measures 5 and 1/2 inches from the center of the u-joint to the tip of the slip yoke.
4. I counted 27 teeth if you include the one that is flat and used as a key to align with the tail shaft on the transmission.

It is your responsibility to make sure this works for your application.

Any questions, please call 2six0-48nine-5three74, no emails please.