3/8" Double Sided Rotary Spot Weld Cutter! Works Great! on 2040-parts.com
Missouri City, Texas, US
|
Use this spot weld cutter drill bit to easily separate spot-welded panels, without distorting the sheet metal. The weld cutter’s double sided 3/8" rotary cutter blade fits most 1/4" drills and separates spot-welded panels more effectively than a panel cutter. This great spot weld cutter is a great addition to the tool kit of any welder! Double sided 3/8" rotary cutter blade Fits most 1/4" drills Provides better panel separations than a panel cutter Overall dimensions: 2-29/32" L x 1/4" Spring loaded pin Double ended cutter blade with eight teeth per end First recommendation is use a center punch to aid in tool guidance. Hold the drill tightly. Periodically clean the bit and oil it while working. The cutter even has adjustable spring tension/length for the pilot tip. Bottom Line: A MUST HAVE WELDING TOOL!!! |
Powered by eBay Turbo Lister
The free listing tool. List your items fast and easy and manage your active items.
Other Parts for Sale
Battery cut-off switch!! - drag race boat rv nos 55-72(US $19.95)
6 piece detail brush set! - hot rod, boat, rv, harley(US $9.95)
320 screw - console door fender bumper trim dash light(US $15.95)
Nylon pry bar installer kit safely removes trim - no scratching or damaging!!!!!(US $16.95)
3/8" double sided rotary spot weld cutter! works great!(US $12.95)
Willys jeep mb gpw cj2a...original t84 transfercase shift lever boot ring(US $0.99)
GM recalls 258,000 SUVs for fire hazard
Mon, 20 Aug 2012General Motors is recalling a family of SUVs, including the Chevrolet TrailBlazer, GMC Envoy, Saab 9-7x, Buick Rainier and Isuzu Ascender, after reports of 28 fires caused by short circuits in the power windows and locks. The recalled SUVs are from model years 2006 and 2007. In total, GM estimates 258,000 vehicles will need repairs.
Nissan reportedly to adapt hybrid system for front-wheel drive
Tue, 21 Jun 2011Nissan Motor Co. is reportedly developing a front-wheel drive adaptation of its in-house hybrid vehicle technology for the next generation Altima Hybrid as early as next year. The system will be based on the rear-wheel-drive hybrid drivetrain that debuted in the 2012 Infiniti M Hybrid, Japan's Nikkan Kogyo business daily says.
Cadillac Converj concept
Sun, 11 Jan 2009Cadillac surprised the press today when it revealed a new 2+2 concept called the Converj. In his introduction to the concept, GM Vice-Chairman Bob Lutz said the vehicle was "pushing the envelope on design quality, and efficiency - everything that makes a great design great". Conceived at GM's Advanced Design studios in Coventry, UK, by a design team led by Simon Cox (Director of GM Advanced Design UK), the project was brought to realization in the US under the leadership of Dave Rand, Executive Director of GM Advanced Design.