86lbs 24v Electric Trolling Motor, Tiller Handle, Ultra Long Shaft, Salt Water on 2040-parts.com
US $319.00
Location:
Richmond, British Columbia, Canada
Condition:New
Brand:SEAMAX MARINE
Manufacturer Part Number:SMX-86X-UltraLong
Seamax
86Lbs 24V Electric Trolling Motor - 40" Ultra Long Shaft
Telescoping Tiller Handle, 5+3 Speeds, Salt
Water Version, Free Circuit breaker
Key Product Features
1). 86lb Thrust, DC 24V input; Ultra Long shaft version for inflatable boat and aluminum boat. Transom mounting bracket with Quick released design; Solid aluminum motor head, 3 brade prop made by nylon & glass fiber. Zinc installed on the motor shaft, and Stainless steel hardware for saltwater & freshwater use. Seamax Limited Warranty provides the coverage for up to two (2) years from the date purchase.
2). Speed Control - Rotate handle clockwise to obtain any of the 5 forward speeds. Rotate handle anticlockwise for any of the 3 reverse speeds. To stop the motor from running, position the handle following the arrow marker and position on level 0. Intuitive telescoping tiller handle & 360° turning, Stainless steel hardware for saltwater & freshwater use.
3). Battery Level/Voltage Indicator - There are 10 LED lights on the top cover, seven of them are green and the rest are red. When seven (7) green LED’s are out, the meter is indicating that the input voltage is less than 19V (normal voltage draw, 24V). It is advised to disconnect the motor from the battery to prevent damage to the battery and recharge the battery. Adjusting Motor Depth Position the depth adjustment collar so the propeller
blades will be submerged 150mm - 300mm (6inches - 12inches) below the water’s surface.
4) Circuit Protection - Free to have a manual reset circuit breaker in the electric outboard motor leads within 1.8m (72 Inches) of the battery(s). Using a circuit breaker could extend up to 2 times of electric motor’s life time in average. Don’t forget to read the manual of motor’s circuit breaker installation standard.
5). Recommended battery(s): 12V Deep Cycle Marine Batter (24/27/31DC) x 2. To extend running time, either purchase a larger capacity or an additional battery can be used. If you want to build the battery group, the battery connection must be parallel type.
|
Product Description
1). SEAMAX trolling motors are designed and developed by professional engineers and have been continually developed over a number of years. There is a wide range of SEAMAX outboard motors, making from 40lbs trust through to 86lbs trust, available on short shaft and long shaft models, to suit every customer’s requirements and application.
2). FIRST TIME RUNNING: (a) Place Electric Outboard onto the back of the vessel in the Stow away position. Loosely tighten Transom Mounting Screws till they grip the Transom Mount. Press the Tilt Lever and slowly let the motor enter the water. (b) Use the Depth Adjuster Collar to adjust the height of motor (Recommend running depth between 150mm and 300mm below the waterline). (c) When you are satisfied that the motor is at a safe depth and isn’t too close or in
danger of hitting the bottom of the lake, river or other water ways you may proceed to tighten the Transom Mounting Screws. (d) Once this is done, it should be safe to connect the battery to the motor. Ensure that the twist grip is in the neutral position and that the nuts are tight on the terminals to prevent a poor connection. (e) Select the desired speed and direction using twist grip on the tiller arm.
3). Power Cable - If extending the standard battery cable supplied with the product, SEAMAX recommends the use of 13mm2 wires (6-gauge wire, AWG).
4). Raising the Motor - It is recommended to disconnect the battery before carrying out this procedure to prevent accidental running of the motor. To raise the motor out of the water push and hold the tilt lever and with the other hand push down on the end of the handle to bring the motor up and out of the water. Then release the tilt lever to lock in place.
|
Free Shipping Service within Canada & USA (48 States)
1). We can ship out your order by most couriers, truck freight, air freight and post service depending the order
2). Courier Shipment transit time is about 3 - 8 business days within USA & Canada after you place the order.
3). Shipping to Yukon, Northwest Territory and Nunavut has additional shipping charge $30.
4). Shipments to (USA) Alaska, Hawaii, Puerto Rico Virgin Islands has additional shipping charge $40.
5). Please contact seller before purchase, International buyer is welcome.
|
WWW.SEAMAXCANADA.COM (USA & CANADA): 1-877-907-7766
Thanks for visiting Seamax eBay Store
|
Complete Trolling Motors for Sale
Tue, 09 Sep 2014
The XE is Jaguar's rival to the BMW 3 Series, Audi A4 and Mercedes C-Class. It's the smallest of Jaguar's sedans, fitting into the range below the XF and XJ. It's the first production model to use Jaguar's aluminum architecture that's intended to reduce weight, yet increase flexibility for both engineers and designers.
Thu, 08 May 2008
By Ben Pulman
Motor Industry
08 May 2008 13:12
Another twist in the will-they-won't-they MG TF saga. The company has announced that production of the roadster will start again at Longbridge from early August 2008, and cars will be in dealerships by September. The first 500 cars off the Longbridge line will be the limited-edition, high-spec LE500.
Fri, 10 Apr 2009
The Mitsubishi Outlander GT Concept will go in to production - expect it in the UK in January 2010
Tagged as a Concept Car when Mitsubishi revealed the first information last week, it has now been confirmed that the Outlander GT will go in to production. It will lose a few of the Concept-Cutie bits, such as the ventilated Brembos and the Oz wheels, but apart from that it will be produced pretty much unchanged. I wasn’t too sure about the Lancer nose when it first came in (although it has grown on me) but it does suit the Outlander GT.