|
Headlight Does Not Comes With Any Light Bulb Or Socket, Please Apply The Stock One HID Included 2 Ballasts, 2 Bulbs |
|
|
|
|
OE Style Crystal Headlight+6000K Slim Ballast Design HID Kit |
|
|
93-98 Jeep Grand Cherokee All Model |
|
|
Not sure your car Model ? Check here |
|
Item Description
- Item is 100% Brand New in Box, Comes In A Pair, Never Been Opened or Installed
Before
- Latest Design OE Style Crystal Headlight With 6000k Slim Ballast Design
HID(High Intensity Discharge) Kit Combo
- Good For Replacing Your Old/Broken Stock One, And Increase Your Vision
At Night!
- Wiring Modification Needed To Connnect The L.E.D Wiring On Some Items, Base
Electronic Knowledge Required
- Gives Your Car a Sporty And Aggressive Look, No More Existing Old-Fashionl
Headlights!
- No Installation Instruction Included, Professional Installation Is Highly
Recommended.
Why HID?Here Below Are The Advantages
of Xenon HID Lights Over Standard Halogen Lights
- HID is 3 Times Brighter Than Standard Halogens, This is Very Crucial Because
Lack of Visibility is The Biggest Cause of Automobile Accidents During Night
Time Driving
- The Viewing Radius Is Increased Up To 70%, Consume 25% Less Power Than Standard,
Plus 25% More Light, It Can Make You Able To See Better In Tougher Weather
Conditions Like Rain And Fog
- It Also Has Much Greater Life Span, Xenon Gas Will Last Up To 10 Years,
Which is About 3 Times Longer Than Standard Halogen Bulbs, And They Can Withstand
a Greater Amount of Vibration And Shock From The Road Due To There Being No
Filament
P.S: When Installing Your HID, Please Becareful,
Do Not Touch The Bulbs And Avoid Any Moisture, Otherwise It Will Cause Not Functioning
Normally Or Not Even Functioning
** Technical Tips If headlights or tail lights are not installed properly, condensation buildup is possible. Please keep in mind, condensation indicates that your light assembly does not have an airtight seal. This is even more likely when living in extreme temperature changing climates. Any brand or even OEM replacement headlights or tail lights are susceptible to condensation if the item is improperly installed. Please make sure all sockets are tightly fastened and all o rings or rubber gaskets are in good condition. Bad o rings or rubber gaskets on your factory sockets can cause moisture. If you happen to have moisture buildup in your lights, please try the following solution. You can simply remove your lights from the vehicle and set out in the sun or in a dry area. Wait until the condensation has fully evaporated, and reseal around the seams with a clear silicone sealant on the assembly and replace any worn down o rings or rubber gaskets. This should alleviate the condensation issue.
|