Can be applied on any smooth flat surface like glass, or any painted surface.
Easy to remove with no sticky things behind,no harm to your paint, car wash safe professional grade vinyl..
Design is cut-out, it is not a solid big piece, The backround color would be the color of your wall or whatever you put it on.
"GOT AN IDEA FOR A DECAL FOR YOUR VEHICLE OR A WALL ? I CAN MAKE ANY DECAL ANY SIZE"
If you want different color , size , reflected image
make sure leave a note when check-out with paypal.
$2.00 S&H USA.
Upon recieving your decal in the mail - unroll and layout flat. Lightly squeegee out any wrinkles caused by the shipping process.
1. Apply to the outside of a window or smooth painted surface. It's very important to clean window or surface with rubbing alcohol not windex. Do not apply in direct sunlight, apply in the shade. Do not apply if the tempurature outside is below 50 degrees. Also, trying the sample decal first will help if your unsure.
2. For larger decals some may prefer the wet installation. NOTE:The wet install works best for solid decals without alot of small pieces, or small text. Wet window with a heavy mist of water, remove paper backing from decal and wet the sticky side with a mist of water also. Apply the decal to the wet surface. After it is in the desired place, squeegee out the water with a plastic squeegee. (You could use an I.D. Card for this.)
3. For smaller decals you can apply dry. Peel off the white paper backing and apply the sticky part to the glass or surface. Applying from one side to the other will reduce air bubbles. Rub or squeegee on with a plastic squeegee. ( I.D. Cards work too)
4. Now, Just peel off the remaining plastic or paper application tape very slowly at a sharp angle away from the decal. If the decal starts to come up as well rub it again or squeegee more then try again patiently.
5. Air bubbles happen. They are a normal part of this type of decal. If you would like you can try to remove them by popping them with a pin and rubbing them, but most will go away on their own. Wrinkles can usually be massaged away with a heat gun.
6. Maintainance tips: Do not over wax vehicle graphics. Using windex to clean the decals may fade them faster.
(also see pictures and step by step illustration below)
Upon recieving your decal in the mail - unroll and layout flat. Lightly squeegee out any wrinkles caused by the shipping process.
1. It's very important to clean window or surface with rubbing alcohol and apply in the shade. DO NOT apply in the sun or to hot glass. Do not apply if the tempurature outside is below 50 degrees. Also, trying the sample decal first will help if your unsure.
2. Tape decal to window like the picture below. Use 3 pieces of tape. (2 in the middle, and 1 on one side as shown below.)
3. You will be applying half of the decal at a time. One the side you didn't tape peel back application paper revealing the sticky side, but not past the middle 2 pieces of tape.
4. Cut the white paper on the back near the center (Not the top part of the sticker, just the bottom paper) and apply that side of the decal to the window from the center out preferably using a squeegee. This "center out method" will reduce air from being trapped and creating those annoying air bubbles.
5. Now since one side is stuck you can remove the remaining pieces of tape. Go to the other side, lift the decal up and remove the rest of the paper backing from the center out. Apply decal from the center out as well.
6. Now all you gotta do is remove the last layer of application tape from the window slowly leaving only the decal cutout left on the window. Peel it slowly at a sharp angle away from the decal.
7. Air bubbles happen. They are a normal part of this type of decal. If you would like you can try to remove them by popping them with a pin and rubbing them, but most will go away on their own. Wrinkles can usually be massaged away with a heat gun.
8. Maintenance tips: Do not over wax vehicle graphics. Using windex to clean the decals may fade them faster. Most decals will last for several years but there is no guarantee as to how long they will actually last.
Pictures for the Exact Positioning Method....It's Easy!
1. Gather simple supplies. For this method you'll need tape, rubbing alcohol, scizzors, napkins, and a squeeqee or credit card. Clean the surface well with rubbing alcohol.
2. Tape Decal to surface as shown using three pieces of tape as shown. Masking tape works well. Make sure you tape it excactly where you want it because that's where it will end up.
3. Peel back side without tape and cut wax paper underneath. You might want a friend to help hold the stick part so it don't fall back on the glass.
4. With the wax paper cut off on one side, get ready to apply half of the decal. Preferably using a squeegee or credit card applying from the center outwards to reduce air bubbles.
5. Apply the one side from center outwards.
6. Remove the three pieces of tape now. Lift the other side.
7. Peel off wax paper backing from where you cut with the scizzors and hold the rest of the decal up and get ready to apply like you did the other side.
8. Squeegee the other side on as you did the first side. From the center out to reduce air bubbles.
9. Once the whole decal is applied, very slowly remove the top layer of application tape at a sharp angle from the sticker.
Note: Some of the logos included on this site are the trademarks or registered trademarks of their respective companies, and are provided as a convenience only for their lawful use. It is the expressed intent of vinyl-4ever that any unauthorized use of these items by the purchaser shall be the sole responsibility of the purchaser. The purchase of any item from vinyl-4ever is not authorization for the use of any specific logo or trademark. By purchasing said logos, you are indicating that you have authority to use the artwork.
Powered by eBay Turbo Lister The free listing tool. List your items fast and easy and manage your active items.
If you have any concerns about your purchase, please contact us before leaving negative feedback. Being negative solves nothing.
If for any reason you are not totally happy with your product. Return it unused for a replacement or a full refund.
"All orders are custom cut when order is placed. I use premium quality 6 yr. outdoor rated vinyl, This will last forever indoor. All decals are available in various colors, If you want your decal a different color than in the first photo, Send Me a message after your purchase with color and any other details. All decals that I have listed can be edited combined with other decals, whatever you want. I can create any decal - any size. Just send me a message with request and I will list it on Ebay"
BriTheDecalGuy - Frequently Asked Questions
Q- Are cars the only things I can apply the stickers to?
A- Absolutely not! You can apply our stickers to any smooth surface. Some great places are: cars, trucks, boats, r.v.'s, motorcycles, skateboards, bicycles, helmets, Walls, tool boxes, mirrors, laptops, trapper keepers and much more!
Q-How do I apply the stickers?
A- We send instructions with every decal order. Decals should be applied to the outside of the car.
Q-What if I want to put the decal on the inside of my window?
A-Send us a message after your purchase and let us know you want the image reversed.
Q- How long does it take to get the stickers?
A- You should receive your stickers in 5 to 7 business days. If you live outside the United States please allow up to 10 to 14 days for delivery.
Q- How big are the stickers?
A- Sticker size varies with each sticker. All decals can be made to a specific size if needed. Each stickers sizes is displayed in the description.
Q- How do I remove the stickers if I want to?
A- Heat the area where the sticker is with a blow dryer and just peel the sticker back off. If their is any sticker adhesive still left on the window just clean it off with window cleaner. If the sticker was on the car paint then just buff the area with car wax.
Q- Can I peel the sticker off and use it again?
A- No, once you've applied the sticker you can not use it again. Once the sticker is removed you will have to throw it away.
Q- I'm putting my decal on my tinted window, What color should I pick?
A- Black will not show up on a tinted or dark window, Pick a light color like white.
Q-How do I get a different size than you have listed?
A-Send me a message through ebay, I will create a custom order just for you.
"Buy any 3 decals and receive a decal of your choice FREE"
Of equal or lower value of lowest purchased decal. No extra shipping USA. If you are charged extra shipping, I will refund it through paypal. After your purchase Send me a message with the item you want for free and your color choices. Do not add free item at checkout.
