Rear Lower and Upper Control Arm
Racing LCA's are forged from T-6061 Aluminum and are designed as direct replacements with at least 3 lb. weight reduction over weaker stock components. These extremely strong and lightweight LCA's help reduce the amount of camber when lowering your vehicle's suspension. As a result, a wider wheel and tire combination can be used with little or no tire rubbing.
Specifics and Benefits:
Adjustable to Minimize Camber and brings Quicker Response
Includes Provision for Sway Bar Endlinks
Improved Suspension Geometry to Reduce Bump Steer
Light Weight, at least 3-4 lbs Less Load to a Vehicle, comparing to OE Stock Products
Made of High Quality CNC Machined T6061 Aircraft Aluminum
OE Type Powder-Coated Bushing Finish for the Highest Durability
Designed to Withstand Tough Road Condition, Big Save on Alignment Every Time after Hitting a Bump
Direct Bolt-On Installation or Replacement
Anodized Finish
4-Piece Adjustable High Strength Front Camber Adjuster Kit
When a cars suspension is upgraded with lowering springs, the result is a lower ride height, a more aggressive look, and better handling due to the lowered center of gravity. While those things are great improvements for the car, the tires suffers from increased wearing and tearing since the tires will slant inwards towards the inside fender. A camber kit will allow the car to remain at the lowered ride height while correcting the angle of the tire closer to the spec it was supposed to be.
Specifics and Benefits:
Corrects Camber +1.25/- 3.00 Degrees and Brings Quicker Response
Ensure Even or Desired Contact with the Ground;
i.e. Tires Wear more Evenly and Increases Traction and Handling
Made of High Quality Lightweight CNC Machined Steel Alloy Material
OE Type Powder-Coated Bushing Finish for the Highest Durability
Direct Bolt-On Installation or Replacement
40mm Aluminum Front Tower + Rear Upper Strut + Rear Lower Tie Bar
A strut bar, strut brace, or strut tower brace (STB) is a car suspension accessory usually used in conjunction with MacPherson struts on monocoque or unibody chassis to provide extra stiffness between the strut towers.
This Combo includes:
1 X Front Upper Strut Bar
1 X Rear Upper Strut Bar
1 X Rear Lower Tie Bar
Specifics and Benefits:
Made of CNC Machined Lightweight T-6061 Aluminum Material
Enhances Steering Response and Stability
Increases Stiffness and Reduces Body Rolling during Cornering
40mm Width
Direct Bolt-On Design Improving Ease of Installation
100% Brand New
Professional Installation is Highly Recommended (No Instruction Included)
Package Includes:
1 X Set (Right+Left) Rear Lower and Upper Control Arms
1 X Set (4 Pieces) of Front Camber Kits
1 X Set of 3-Piece Front Tower + Rear Upper Strut + Rear Lower Tie Bars
Hardware as Shown in the Picture Above
Application:
90-97 Honda Accord
CB1/ CB2/ CB3/ CB4// CD3/ CD4/ CD5/ CD6
Note: Spring rates and drop amounts might vary by different vehicles application and chassis loads
* Professional Installation Highly Recommended! No instructions included! *