Special designed for replacing the rear axle mounting bushes, whilst in situ on the vehicle and without the need for removing the rear axle assembly.
it's fine thread and thrust bearing allows the bush to be fitted quickly and easily without causing damage.
5-piece tool set designed specifically to press-in the bushings that are located in the rear axle twist-beam of MKIV Golfs and Jettas.
This tool makes it possible to service these bushings on the vehicle without removing the rear axle and brake system, thereby saving significant time and effort.
Typically the old bushing is removed by cutting or burning out the rubber and then slitting or hammering out the bearing shell. This tool is then used to press the new bushing into place. This can be done on the vehicle and does not require removing the axle to allow access to a traditional press.
It's fine thread and thrust bearing allows the bush to be fitted quickly and easily without causing damage.
Application: Audi A3/ VW Golf IV/ Bora 1.4/ 1.6/ 1.8/ 2.0 and 1.9d (2001~2003)
1998-2005 New Beetle
1999-2005 Golf (incl. GTI)
1999-2005 Jetta (incl. GLI)
2003-2004 R32