|
Headlight Does Not Comes With Any Light Bulb, Please Apply The Original One Bumper Light Has No Light Bulb or Socket Included, Please Apply The Stock One Fog Light Comes With H3 Light Blub, Wiring Harness, Switch, Bracket And All Accessories! |
|
|
Headlight: Black Housing Bumper Light: Black Housing Fog Light: Smoke Lens |
|
|
Crystal Headlights+Bumper Light+Halo Projector Fog Light Combo |
|
|
99-02 GMC Sierra 1500 01-02 GMC Sierra 1500 HD 99-02 GMC Sierra 2500 01-02 GMC Sierra 2500 HD 01-02 GMC Sierra 3500 01-02 GMC Sierra C3 00-06 GMC Yukon 6.0L, 8 Cylinder - Yukon XL 2500 00-06 GMC Yukon 5.3L, 8 Cylinders ***DOES NOT FIT DENALI MODEL*** |
|
|
Not sure your car Model ? Check here |
|
Item Description - Item is 100% Brand New in Box, Never Been Opened or Installed Before
- Latest Design Crystal Headlights, With Halo Projector Fog Light+Bumper Light Combo, Good For Replacing Your Old/Broken Stock One
- Wiring Modification Needed To Connect The L.E.D Wiring On Some Items, Base Electronic Knowledge Required
- Gives Your Car a Sporty And Aggressive Look, No More Existing Old-Fashion Headlights, Bumper Light And Increase Vision At Night!
- No Installation Instruction Included, Professional Installation Is Highly Recommended.
** Technical Tips If headlights or tail lights are not installed properly, condensation buildup is possible. Please keep in mind, condensation indicates that your light assembly does not have an airtight seal. This is even more likely when living in extreme temperature changing climates. Any brand or even OEM replacement headlights or tail lights are susceptible to condensation if the item is improperly installed. Please make sure all sockets are tightly fastened and all o rings or rubber gaskets are in good condition. Bad o rings or rubber gaskets on your factory sockets can cause moisture. If you happen to have moisture buildup in your lights, please try the following solution. You can simply remove your lights from the vehicle and set out in the sun or in a dry area. Wait until the condensation has fully evaporated, and reseal around the seams with a clear silicone sealant on the assembly and replace any worn down o rings or rubber gaskets. This should alleviate the condensation issue.
|