**** NEW PRODUCT ****

BALL JOINT SPACERS

YOU ALL HAVE BEEN ASKING FOR THEM I HAVE THEM READY TO SHIP

I HAVE DONE A LIMITED RUN ON THESE SPACERS. IF THEY SELL WELL I WILL GO INTO FULL PRODUCTION ON THEM.

THESE HAVE NOT BEEN PRODUCED AND SOLD IN OVER 40 YEARS !!!!!!!!! These are BRAND NEW made buy me HOTCHEVY60 bring you another loss product of the past. These fit all 62 to 67 CHEVY II. They are designed to allow the front end of the vehicle to raise further under acceleration and deliver a better weight ratio to the rear tires. It allows the front end to rise as much as 6" under hard acceleration for maximum weight transfer. It is recommended for street or strip.

These were made in the 50'S 60'S & 70'S . The originals back then were made of Cast Aluminum and could break (and they did break)

UNLIKE THE ORIGINALS MADE IN THE 50'S & 60'S THAT WERE LOW-GRADE CAST ALUMINUM.

THESE ARE MADE FROM 6061-T6 AIRCRAFT QUALITY BILLET ALUMINUM. THESE ARE CAD DESIGNED, CNC MADE BY REAL AMERICANS RIGHT HERE IN NEW JERSEY, USA !!

THE KIT COMES WITH ALL GRADE 8 BOLTS AND HARDWARE AND INSTRUCTIONS. THEY INSTALL IN 20 - 30 MINUTES PER SIDE.

UNLIKE THE ONES MADE IN THE 50'S TO 70'S

THERE IS NO NEED TO MODIFY YOUR UPPER CONTROL ARM OR BALL JOINT.

THEY DO CHANGE THE STAND STILL HEIGHT OF THE CAR 2 INCHES. THEY DO CHANGE THE NORMAL DRIVING HEIGHT OF THE CAR 2 INCHES. YOU CAN GET AS MUCH AS A TOTAL OF 6 INCHES OF LIFT DEPENDING ON THE COIL SPRINGS IN YOUR CAR

REMEMBER THE OLD DAYS ?? WHEN THAT GUY PULLED OUT OF THE HOP OR THE CORNER GAS STATION. WHEN HE PUT THE PEDAL TO THE METAL, THE FRONT OF THE CAR RAISED UP !!! WELL, THIS IS HOW IT WAS DONE.

WHEN YOU PUNCH IT, PULL A HOLE SHOT, GET ON IT. THE NOSE IS GOING TO RAISE UP AND YOU ARE GOING TO LOOK LIKE KS PITMAN, DYNO DON, OR WHO EVER YOU WANT TO BE !! YOU WILL BE SURE TO WOW THE CROWD !!!!!!!

I WILL SHIP THESE ANYWHERE IN THE US 48 PRIORITY MAIL FREE SHIPPING !!

FITS CHEVY II 6CYL 283 327 396 427 402 454 502 SMALL BIG BLOCK 1962 1963 1964 1965 1967