Model T Mainbearing mold

 

This mold is used when pouring the Babbitt bearings in a model T Ford Block

Unlike most vintage tool designs this unit will pour both the motor block and bearing caps (1 bearing at a time)

Bearings are poured 1/8” undersize in diameter and will have approximately .030” excess material on each side of the thrust flanges

This allows the use of any standard dimension or reasonably undersized model T crankshaft

Excess materials on thrust surfaces allow for correct positioning of crankshaft to achieve necessary mag coil clearances

Instructions and my telephone or e-mail support are included with mold.  This is the most current revision of my original designed tooling

I have been building and selling this basic, functional design since 1979

I also build molds for model A and B 4 cylinder Ford engines and 2 types of mainbearing linebore units.