Chevy Intake Manifold Kit, LS1 & LS6 Engine, Edelbrock, 1955-1957



     
  • Allows You To Run A 4-Barrel Carburetor On The Fuel Injected LS Or Vortec Engines
    •  
  • Dual Pattern Carburetor Flange For Square Or Spread Bore
    •  
  • Uses Factory Sensors & Coils (Not Included)
    •  
  • Works With Pre-2006 24X Crank Sensor Engines Only
    •  
  • Solid State Electronics
    •  
 
 So, you have a carbureted small block and you keep seeing other Chevys making great great power with less cubic inches using the 1999-2005 LS engines. Here is your chance to use a late model (1999-2005) GM Vortec or 1997-2004 LS engine in your classic without all the computer and fuel injection junk. This kit, developed by MSD & Edelbrock, will let you use any Vortec 4.8, 5.3, 6.0, or the 5.7 LS1 or LS6 (1997-2004). The smaller 4.8 & 5.3 are plentiful and very affordable in salvage yards due to the complexity of the computer and wiring. All you need with this kit is a carburetor, the factory sensors and coil packs and the engine from the donor vehicle. The Edelbrock/MSD ignition controller plugs into the factory sensors and coil packs and handles all computer tasks, while the carburetor handles the fuel. The controller comes with 6 pre-set spark curves which will let you run whatever octane fuel you desire. Brackets are included to mount GM accelerator cables and TH350 & 700R4 Detent/Kickdown Cables.


Customers Like You Also Viewed:
Frooition www.frooition.com | eBay design, eBay store design, eBay shop design, eBay template design, eBay listing design
This listing is currently undergoing maintenance, we apologise for any inconvenience caused.