ITEM DESCRIPTIONS
DRIVERS LEFT SIDE VIEW REPLACEMENT MIRROR GLASS. MANUAL AND LEVER OPERATED MIRROR.
PART NUMBER: 2447
USES: THIS REPLACES THE CURRENT EXISTING DRIVERS LEFT SIDE VIEW MIRROR GLASS.
DIMENSIONS: HEIGHT - 3 5/8", WIDTH - 6", DIAGONAL - 7 3/16"
INCLUDES: THIS MIRROR GLASS COMES WITH THE GLASS, ADHESIVE TABS, AND EASY INSTRUCTIONS.
WARRANTY: FOR DEFECTED PRODUCTS
THIS DRIVERS LEFT SIDE VIEW REPLACEMENT MIRROR GLASS FITS:
1985 CADILLAC DEVILLE
1986 CADILLAC DEVILLE
1987 CADILLAC DEVILLE
1988 CADILLAC DEVILLE
1989 CADILLAC DEVILLE
1990 CADILLAC DEVILLE
1991 CADILLAC DEVILLE
1992 CADILLAC DEVILLE
1993 CADILLAC DEVILLE
1986 CADILLAC FLEETWOOD
1987 CADILLAC FLEETWOOD
1988 CADILLAC FLEETWOOD
1989 CADILLAC FLEETWOOD
1990 CADILLAC FLEETWOOD
1991 CADILLAC FLEETWOOD
1992 CADILLAC FLEETWOOD
1986 CADILLAC SEVILLE
1987 CADILLAC SEVILLE
1988 CADILLAC SEVILLE
1989 CADILLAC SEVILLE
1990 CADILLAC SEVILLE
1991 CADILLAC SEVILLE
IT IS THE BUYERS RESPONSIBILITY TO MAKE SURE THAT THIS IS THE CORRECT PART FOR YOUR VEHICLE. CHECK OUR DIMENSIONS WITH YOUR CURRENT VEHICLE DIMENSIONS TO MAKE SURE THAT YOU ARE PURCHASING THE CORRECT MIRROR GLASS FOR YOUR VEHICLE. WE ARE NOT RESPONSIBLE FOR YOUR PURCHASE SINCE THERE ARE SEVERAL DIFFERENT MIRROR GLASS STYLES AND SIZED FOR THE SAME VEHICLES.
OUR SIDE VIEW MIRROR REPLACEMENT GLASS, REPLACES THE OEM MIRROR GLASS OF YOUR VEHICLE. IT WILL NOT FIT IF YOU HAVE AN AFTERMARKET SIDE VIEW MIRROR.
INSTALLATION INSTRUCTIONS
PRIOR TO INSTALLING, HOLD GLASS UP TO YOUR MIRROR HOUSING TO CHECK CORRECT SIZE AND SHAPE.
WHEN OLD GLASS IS CRACKED OR DISCOLORED BUT STILL IN ONE PIECE:
1. CLEAN OLD GLASS WITH ALCOHOL BEFORE APPLYING CUSHION TAPE TO IT.
2. POSITION NEW GLASS CAREFULLY AND APPLY DIRECTLY OVER THE OLD MIRROR.
WHEN OLD GLASS HAS BROKEN OR MISSING PIECES:
1. CAREFULLY REMOVE ALL BROKEN PIECES OF GLASS FROM MIRROR HOUSING. USE HAMMER TO TAP OUT THE GLASS AND /OR RAZOR TO SCRAPE OFF DRIED ADHESIVE IF NECESSARY. CAUTION: ALWAYS USE SAFETY GOGGLES AND GLOVES.
2. APPLY CUSHION TAPE TO MIRROR HOUSING AND PRESS NEW GLASS INTO PLACE.
WHEN MIRROR HOUSING CONSIST OF TWO HALVES ASSEMBLED WITH SCREWS:
1. REMOVE SCREWS AND TAKE MIRROR HOUSING APART. SLIDE OUT OLD GLASS AND RUBBER GASKET.
2. PUT RUBBER GASKET AROUND NEW GLASS AND REPLACE INTO MIRROR HOUSING.
3. REPLACE AND TIGHTEN SCREWS.
WHEN MIRROR HOUSING IS CLAMPED OVER GLASS WITH A RUBBER GASKET:
1. MARK GASKET WITH PEN TO INDICATE PROPER POSITION FOR WHEN YOU RE-INSTALLL.
2. USE HAMMER IF NECESSARY TO TAP OUT OLD GLASS AND REMOVE ALONG WITH GASKET. CAUTION: ALWAYS USE SAFETY GOGGLES AND GLOVES.
3. PUT RUBBER GASKET AROUND GLASS AND REPLACE INTO MIRROR HOUSING. WORK RUBBER CAREFULLY INTO HOUSING WITH WIDE FLAT SCREWDRIVER OR SIMILAR TOOL. LUBRICATE WITH SILICONE OR SOAPPY WATER IF NECESSARY.
