Description
You are purchasing a NEW:
Chevrolet Corvette C4, C5 or C6 Fender Racing Stripes, 5D Carbon Fiber vinyl Kit.
These NEW Carbon Fiber vinyl Fender Racing Stripes were custom cut out by the owner of the Predator Corvette. Its very easy to install, fits C5 or C6 vehicles.
The material is carefully cut, the Premium 5D Top Grade Shinny Gloss Carbon Fiber vinyl gives you a beautiful factory appearance.
Whats included:
1. 1 side = 1, 2" and 1, 3" Fender Racing Stripes
2. If you purchase both sides: 2, 2" and 2, 3" Fender Racing Stripes, 1 set for the Driver side and 1 set for the Passenger side.
These Racing Stripes are made of carbon fiber vinyl, This is NOT REAL CARBON FIBER.
When installing the racing stripes, make sure the surfaces that you apply the material to must be smooth, non porous, and thoroughly cleaned from dust, grease, or any other contamination.
We are not responsible for improper installation. If you have any questions before you purchase, please email us.
Our Vinyl is a dual cast file specifically designed to provide dimensional stability and durability without the need for an over laminate. The pressure-activated adhesive allows you to re-position the film until you apply firm pressure.
About the Carbon Fiber vinyl:
- Re-positionable vinyl for trouble-free install
- Strong self adhesive, peel and stick application. Just trim off excess with knife
- Extremely high gross and smooth finish
- Stretchable with heat
- High temperature & water resistant
- Install Temp: 60F to 80F (16C to 32C)
- End Use Temp: -65F to 225F (-60C to 107C)
- Easily cleansed with water and soap
- Long lasting for around 4-5 yr outdoor / 12 yr indoor
Installation Recommendations:
This vinyl can be installed using 3M Primer 94 and 3M Edge sealer, these are recommended by 3M vinyl wrap training class, these products will promote adhesion and add life to your vinyl. We would highly suggest using a 3M primer 94 or professional installation.
Installation Instructions:
1. Make sure the surfaces that you apply the material to is smooth, non porous, and thoroughly cleaned from dust, grease, or any other contamination.
2. You can apply the racing stripes with the angled edge at the hood and the other end at the tire, you will need to trim the excess off the tire end.
3. When you have the location you want to put the racing stripes, Peal off the backing from the decal (NOTE: pull off slowly.) exposing the adhesive side. Start from one side, stick the decal to the surface, then using a squeegee or a credit card wrapped in cloth to make sure it does not scratch the decal, start working your way to the other side of the decal applying pressure with the squeegee or credit card in order to remove the air bubbles. Be sure to apply pressure on the edges to make sure it is securely stuck on correctly.
4. When the vinyl has been applied, remove the clear film on the top and trim excess.
5. If you still have air bubbles under the decal, use the squeegee or credit card to work the bubbles out. Start from the middle of the decal and work them out to the edge.
Shipping information:
Shipping in the USA: Free Shipping.
International Shipping: Shipping is calculated by your Country and zip codes. USPS Priority International (6-10 Business days)
International Buyers: We don't have knowledge of other country's laws outside of the USA so please make sure that your postal service will allow the item into your country before buying them. We are not responsible for custom taxes or levies your country may charge you.
