Click Here. Double your traffic. Get Vendio Gallery - Now FREE! LIMITED PRODUCTION RUN OF THE OEM YAMAHA VIPER BLUE WITH LOGO! We only make a few of these each season and are hot sellers! New aftermarket seat cover for 97-02 Yamaha VMAX SX SRX and SXR models. This is the model with the side pads, not the standard VMAX seat cover. Subzero cold crack marine grade vinyl. Top seating area vinyl is a unique Multi-way stretch good for -65'F cold crack. We were the first and remain the only ones to utilize this material as it is 4x the cost of standard vinyl. Due to our buying power, we can afford to include this material as standard on all of our snowmobile seat covers, unless otherwise requested. OEM YAMAHA VIPER BLUE AVAILABLE ONLY THROUGH US! We bought all of it. OEM VIPER BLUE ONLY AVAILABLE HERE! MADE IN THE USA!!! Listing is for seat cover only. Not the complete seat assembly. We now own the remaining stock of the NOS OEM Yamaha SRX/Viper Blue vinyl. There are limited quantities of that vinyl left. Therefore we limit the production of this cover each season. Please allow 2-5 business days to complete your order. This does not include shipping times. After Labor Day we experience extremely high order volumes, so please plan ahead when placing your order. We do not place any orders ahead of another customer. During the Holidays, please allow extra time to get your seat cover due to production and shipping delays we experience at those times. In off season, Easter through Labor Day, we may ship only once a week.RETURN POLICY: NO RETURNS. Limited production run. Please read the return policy in detail prior to purchase. We warranty our products to be free of defect and of good quality. If there is an issue with the order on our end, we will make it right no matter where we ship to.You have 7 days from time of receipt to contact us about a defect. We make every effort to take care of our customers. If you make a mistake, you now have a spare. We do not accept returns due to customers choosing the wrong seat cover, inability to install, nor do we accept any covers that have been installed. We cover our mistakes and our mistakes only.
Installation. Unless specified with special instructions, most seat covers are installed by removing your stock seat cover and installing the new one using a staple gun. For most Arctic Cats, you will need to use the existing lumbar seam rod(metal rod that goes in the lumbar seam where the straps are attached to the seat) and the U shaped rod that holds the straps through the foam from your old seat. Those are no supplied. A fabric steamer(hand held ones work fine and are available at Walmart or other department stores for under $20) work very well to help remove the remaining wrinkles. You can also use a hair dryer carefully on low heat. Some seat covers or seat mod kits may require the use of 3M 90 Spray(Home Depot, Hobby Lobby, Joannes Fabric, and other hardware stores) adhesive to assist in the installation. We will usually notate in the listing any special instructions needed if applicable. To save on trees and waste, we do not include instructions with the shipment. Most seats do not come with tail light holes cut out. Because these patterns may fit multiple models that had a tail light mounted on the tunnel, we do not cut them out and leave that for you to complete. This is the case with most Arctic Cat, Polaris and Yamaha seats. Most Skidoo seats have a recessed tail light pocket and that is included as part of the pattern. Please feel free to ask any questions we will help out where we can. We are constantly working on
adding new models to our line up. Please visit our Ebay store to see
our listings. If you do not see what you need, please ask and we will
assist you. International Buyers – Please Note:
|