Enderle's blown alcohol Birdcatcher injector is complete setup  for 370-550 cu in engines*

When buying please tell us : Cu in- Blower Type- Elevation where you run usually- How much boost you plan on Using

Available for :

BB Chevy, SB Chevy, BB MoPar, SB Ford, - be sure to SPECIFY

• Injector- w barrel valve -fuel lines -nozzles & bodies -check valve -distribution block -bypass pills-4-3/8" Butterflies
• Fuel Pump-  80A or 600 or 110 we will select * Waterman pumps avail at  Alkydigger
• Belt Drive for fuel pump , or Timing Cover Drive * Specify what drive you want
• 6" Fuel pump Extension
• 3 Way #8 AN Shut off Valve
• Fuel Shut off Cable kit
• Alcohol Screen Fuel Filter
• Gasket between Injector and Blower
• Red Butterflies
• *

* Blower shown in pictures  not included

Our Casting Disclaimer:

Hilborn and Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

 In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.