Brand: Not Applicable
Condition: 100% brand new and high quality
Note: PCB may be modified according to the actual situation, as well as functional improvements, If there is no particular change, no another reminder.
Length: 40.2mm, Width: 12.8mm, Thickness ≈7mm
Display Color: Red
Display Mode:
① display time only
② display temperature only
③ display voltage only
④ time temperature voltage alternating display (Note: alternate display mode, choose whether display the temperature or voltage with dd option, dd: display Time + temperature + voltage under 0 status .dd: display time + voltage under 1 status. dd : display time + temperature under 2 status )
Features:
1. There are three functions:displays time, temperature, voltage
2. With manual temperature error correction function, setting range -5 ~ 5 ℃
3. With backup battery, power-down time to continue to work
Electrical Characteristics:
1. Input voltage 5 ~ 30V. Note that need to use a voltmeter function, the input voltage is at least more than 7V
2. Voltmeter range 7 ~ 30V, error ± 0.1V, the measured voltage is the input voltage. (Can also used as a wide range of voltmeter, power is more convenient, such as laptop power supply is ok, and do not exceed the maximum voltage of 30V)
3. Temperature measurement range change to -50 - 130 degrees, the temperature resolution is up to 0.1 degrees
4. Working current is about 30MA
How to use:
1. Adjust the time and temperature error correction
Under normal using, press the "left", "minute" starts flashing, then press the "Right", "minute" increase, and cycles between 59 to 0 . adjust "minute", then press "left", "hour" starts flashing, then press the "Right", "hour" increase, and cycling between 23 ~ 0, after adjust "hour" and then "left", will disply AC: xx, value of xx is the corrected temperature value, it is the degree, press the "Right" to adjust the temperature error correction value, range is from -5℃~5℃, positive number is increased, negative number is reduce, after adjust temperature error correction, press "Left", save all the data, and return to normal display.
(Note: After long time working, such as measured temperature is a little high, it is because the regulator circuit on board is heating, and the board is relatively small, the heat transfer to the resistance, so that the measured temperature is high, the solution is to pick out the temperature resistance with some lines, make it left the board, that can be solved)
2. Switch the display mode
In the non-adjustment of status, press the "right" to switch the display mode, ① only displaying the time → ② only display temperature → ③ only display the voltage → ④ time temperature alternating display , cycling change. And save the final model, even power off and then on.
Packing List:
1 pcs LED time clocks,
1 pcs Pinouts