|
The Product: A set of new master cylinders with levers (and
an extra pair of master cylinders without levers for back ups) for use on the
1999 Excelsior Henderson Super X motorcycles and custom choppers with 1"
handlebars.
Research: We received these through a buyout and all of the information we have
on them is listed here. We received a variety of items through the buyout for
American Ironhorse, Big Dog Motorcycles and Excelsior Henderson motorcycles;
however these master cylinders/levers were not labeled in any way to indicate
what they were designed to fit. We found a Rider’s Handbook for 1999 Excelsior
Henderson Super X motorcycles which shows levers and master cylinders which
appear identical to these. If you go to the SuperXOwners website and view the
1999 Super X Rider’s Handbook you can view pictures which show identical
controls in Section 9: Maintenance. Unfortunately since there are not any part
numbers on these we are unable to verify this therefore we ask you closely
compare these controls to your existing ones to help determine if these will
fit your motorcycle.
To help you determine if these will fit your motorcycle we
have measure them. The clamp which mounts these to handlebars measured 1"
in diameter, and as shown in the second picture we loosely mounted these to
1" handlebars to show you how they look mounted onto a handlebar. The
levers are about 7-1/2" long. The threaded hole where the brake lines
enter the masters measured about 3/8", we do not know what the thread size
is. The right side master cylinder has prongs to connect electrical wiring to
that we think is the front brake light switch. The covers state you are to use
only DOT 5 brake fluid in these. Stamped into the right side reads: 1/2 Nissin.
Stamped into the left side reads: Nissin 14. As stated above we do not know
what motorcycles these were designed to fit; however we do believe you can
adapt them to be used on custom choppers. Please look over the pictures,
compare the measurements provide and review our return policy noted below prior
to purchasing this lot of two complete master cylinder/levers assemblies and
extra master cylinders.
Layout of Pictures: The first picture shows everything included in this
listing. The second picture shows the complete assemblies loosely mounted to a
set of 1" handlebars, the handlebars are NOT included in this listing. The
third and fourth pictures show both the right and left side master cylinders
close up. In the fifth picture you can see the master cylinders from another
angle which shows the stampings on these.
Condition: These are new and in good shape aside from some light scratches and
rub marks caused by them being moved around warehouses for some time.
|
