Headrest Badge Decal

Dashboard Badge Decal (Brushed Aluminum Sticker)

In this auction, you will get (2) pieces of Dashboard badge decal (stickers) for your ride.

Those were machine cut by brushed aluminum material decal , made by 3M material, very high

quality and durable.

It is suitable for stick on Leather / Vinyl /plastic dashboard. Also suitable to stick on exterior

body panel ( metal, plastic, bumper, spoiler ,window glass ...) you can also stick on your

laptop computer if you like, just use your imagination

Esay DIY installation in less than 5 minutes, peel off the transfer tape and stick it on

Will NOT leave any mark or dirt on your leather seats when removed

For General Dashboard Decal Application

1) CLEAN DASHBOARD SURFACE COMPLETELY with alcohol, windex or soap water. Dry with paper towel completely. Make sure that the surface is free from dirt, grease, dust or water. Decals must be apply onto the dry surface.
(Tips: Use alcohol for cleaning has the best result, After cleaning, Do not contact the decal apply area by finger or hand again. Grease may reapply to the surface.)

2) Peel paper backing from decal. Position on the center of the headrest. Apply carefully. (Important: Please do not try to apply them multiple times. Adhesive will damage if re-apply.) Once the adhesive touch the surface and using moderate pressure (DO NOT PRESS TO HARD), rub all areas of the decal only.

3) Slowly peel the transfer tape away very careful from the decal. Make sure the vinyl sticks to your surface and comes away from the transfer tape.
(Tips: sometime the transfer tape will stick very hard on to the decals. That's normal, Just carefully peel them off)

4) After the Transfer tape is completely come off. Rub all areas of the decals using moderate pressure (Do not press to hard onto the decals where rubbing the area).

5) Allow decals adhesive to set up for 2 - 3 days before cleaning.

We accept PayPal