Parting out my project car. This kit is for a small block ford. I had them in a 1964 galaxie but obviously will work for a lot of different vehicles. This is a turbo kit that I put together and it has been run a total of 5-10 minutes. I could sell everything as new but that would be dishonest. But everything does look new. Just lost interest. My loss is your gain! I am selling the following parts as a kit but I do have everything in picture for sale if there is more you need. Parts included in kit is as follows:

Borg Warner s300sx3-63 .88 ar T4 airwerks turbo with billet return flange installed. Will include oil supply hose and oil return hose. 

High quality turbo headers with crossover tube and downpipe with Wastegate flange welded in. Headers are ceramic coated and wrapped with titanium high heat wrap. Will include header bolts and all hardware.                        

Extreme velocity carb hat with nipples installed

50mm BOV

Intake tube that runs from turbo to carb with BOV flange installed. Ceramic coated. Will include silicone boots for turbo and carb end and clamp for BOV

Precision 39mm Wastegate 

All nessesary v band clamps 

These are all high quality parts and not a cheap China eBay set. And they are as close to new you can get.  If you were to buy everything new you'll spend over $2000 with ceramic coating. And again I do have everything in picture available including quick fuel e85 carb, 6btm ignition, msd distributor and coil, edelbrock boost referenced fuel regulator, magnafuel QuickStar fuel pump, aluminum heads, etc.....  I also have the motor itself and a built c4 transmission but those could be tricky to ship. 

Thanks and good luck