Please Note

I will sell internationally. Taxes and duties are the responsibility of the buyer

Contact me for the mailing cost both in Australia and overseas prior to bidding. The postage cost on top of the page is incorrect and I can't change it!

The photos form part of the item descriptions.

This is a GENUINE Weber 32/36 DGV 5A manual choke Carburettor with factory jetting as follows:

Primary venturi -----------------26mm            Primary Idle Jet----------0.55mm

Secondary venturi --------------27mm           Secondary Idle Jet--------0.50mm

Primary Auxilliary Venturi-------3.5mm          Primary Emulsion Tube--------F50

Secondary Auxilliary Venturi----3.5mm         Secondary Emulsion Tube------F6

Primary Main Jet---------1.40mm       Pump Inlet Valve with back bleed--- 0.40mm

Secondary Main Jet------1.35mm       Pump Jet----------------------------0.50mm

Primary Air Corrector Jet-------1.65mm        Needle Valve----------------2.00mm

Secondary Air Corrector Jet-----1.60mm       Float Measurement---------- 36.5mm / 46.5mm

 Would suit Ford 1.6/2.0 Cortina, Ford 1300 x/flow engines, Capri,  Celica, Datsun, Corolla, Escort, Gemini, Vitara, Sierra, Rodeo, Jackaroo, Toyota 3k-5k Motor, kit car etc. or can be adapted to suit many other engines.

It is not a Chinese copy.

It is in perfect condition as I only used it for about ten minutes.

I am only selling it because it does not suit my requirements.

It comes with:

Ramflo reusable (washable)  air filter

Complete Adaptor kit (two adaptor plates and offset studs )

Complete Linkage kit for accelerator cable

5mm Phenolic (Bakelite) Base Block with gaskets each side

Choke Cable

A #40 Primary Idle Jet is included

*****************************

All the above are in as-new condition

 If you have any questions just ask.

 You can be assured of my integrity as my 100% feedback score attests.

 Thank you for taking the time to  look at my offering and good luck if you bid