Compatible Vehicles:  2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 Toyota Sienna w/ 1 power sliding door

FCC ID: GQ43VT20T

Part#:                  1470A-1t IC: 14701-1T MEX: RLVTR5002-562

Dealer part#       89742-AE020

Buttons:              4: Lock, Unlock, Automatic Power Sliding Door, Panic

Frequency:         315 MHz

Battery Type:     1: CR2032

Program Instructions:
1.  Start with the following conditions:

a.       Key is out of the ignition

b.      Driver door is open (all other doors are closed)

c.       Driver door is unlocked (other door locks don't matter)

2.  Insert the key into the ignition (don't turn it) and pull it out.
3.  Perform these steps within 40 seconds:

a.       Using the power lock/unlock switch on the driver's door (with the driver's door still open and locked), perform 5 lock/unlock cycles starting with lock. A lock/unlock cycle consists of pressing the power lock switch, followed by pressing the power unlock switch on the driver's door panel. Use an even pace and try to go relatively fast.

b.      Close, then open, the driver's door.

4.  Perform these steps within 40 seconds:

a.       Using the power lock/unlock switch on the driver's door, perform 5 lock/unlock cycles starting with lock, as you did previously.

b.      Turn the ignition to "ON" (as far as you can go without cranking your engine), then back to "OFF".

c.       Again, turn the ignition to "ON" (as far as you can go without cranking your engine), then back to "OFF".

d.      Remove the key from the ignition.

5.  Within 3 seconds, the power door locks should cycle (lock then unlock) automatically, indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.6.6. 6.  Perform these steps within 40 seconds:

a.       Press the lock and unlock buttons on the transmitter (the remote) simultaneously for 1 second.

b.      Immediately after letting go of the lock and unlock buttons, hit the lock button by itself and hold it for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks don't cycle, or cycle twice, repeat steps 6a and 6b, as this means the remote has not been accepted.

c.       Repeat steps 6a and 6b for each transmitter that will operate the vehicle, including any old transmitters.

7.      7.  Close driver's door.

First off, notice the bold in step 6 c). You have to repeat 6 a) and b) for EVERY remote, both your old ones that were already working, and your new one(s). And you have to do it before closing the driver's door in step 7.

Second, don't test your remotes until you've completed step 7. Then go ahead and test all of them. If you press one of the buttons on the remotes before having completed everything and closing the driver's door, the programming will not be successful.