RM1000

Turn your 12Vdc LED lights on and off with flash. This kit is especially designed for use with 12v LED lighting device, it has 4 different flash modes to choice from, modes are preset by the factory and there is not necessary to make any adjustment, with built-in programmed integrated circuit, it will memorized your last timer mode when the device is turn back on.

Flash mode: 0.25sec, 0.5sec, 1sec, and steady "ON"

Toggle remote button each time to switch between mode, press off to turn off operation

What's in the kit:
-Package included: 1 receiver + 1 remote controller (battery included)
-Dimensions on receiver box: 2 1/8" x 2 1/4" x 1 1/4" (8cm x 5.5cm x 3.5cm)
-Operating voltage: 12Vdc (do not exceed 15Vdc to avoid overload) 
-Remote control operating range: 0~22ft (tested in open area, range may vary depend on area)
-Remote control bandwidth: 315Mhz
- 2 buttons remote control: {f} for toggle between modes, {off} for shut down power.
-Built-in LED timing mode indicator on receiver box for easy navigating  lighting control
-Memorize your last setting on next power up (reset if main power is cut off)

Wiring:
-Red wire: positive power input (use 12vdc only, do not overload)
-Black wire: ground/negative power input
-Green wire: Antenna (caution: make sure it does not touch any power source to prevent short to receiver)
-Yellow wire: connect to lighting device positive
-Blue wire: connect to lighting device negative/ground

-Do not connect directly to any 120/240VAC power without using a 12V AC/DC converter or adapter.

Visit My eBay Store: Click and Lights