|
This Item Does Not Come With ON/OFF Switch. Comes With Screw,Bolt,Bracket And Around 48 Inches Wiring For Installation ***PLEASE DOUBLE CHECK THE AVAILABLE SPACE IN THE PRIOR PURCHASES*** |
|
|
|
|
More Brighter Than The Other Aftermarket DRL LED Lights. 2pcs Euro Design 6 Hyper White(6000K-7000K)LED Daytime Running Light. |
|
|
For 11V to 13.5V Vehicle Only. The Compatibility Table only for Reference. |
|
|
Not sure your car Model ? Check here |
|
Item Description
- Item is 100% Brand New in Box, Never Been Opened or Installed Before
- LED Daytime Running Light is a New Type Environmental Protection Product
- More Brighter Than The Other Aftermarket DRL LED Lights.
- The Whole Set Lamp is Made of High Quality Aluminum With No Pollution, No
Noise, No Electronic Interference
- Oxidation Treatment On Surface. Nice Appearance With Good Shake-proof, Waterproof,
And Corrosion Resistant
- Extremely Long Lasting Life And Low Power Consumption, And Can Be Function
As LED Fog Light, But ON/OFF SWITCH IS NOT INCLUDED
- Advanced Constant Current Technology, Well-Distributed Luminescence, Also
Will Better Enhance The Safety of Driving In Daytime And Nighttime
- Lamps Are Commonly Adopted By The Newest European Luxury Vehicles Such Audi
A5, Q7 etc, Therefore
These Lights Will Give Your Car an Awesome And Eye-Catching Euro Luxury Look.
- For Installation, The Negative Wire Need To Connect To The Negative Side
of Battery. The Positive Wire Need To Get Power From The Ignition Fuse Box.
Therefore, The Daytime Running Light Will Turn On When The Key Ignition On.
- Although The Installation Seems Like Easy, But No Installation Guide/Instruction
Included, Professional Installation Is Highly Recommended.
- ***DRILLING/MODIFICATION MIGHT BE REQUIRED
ON SOME VEHICLES, WE ARE NOT RESPONSIBLE FOR ANY DAMAGE DUE TO INSTALLATION***
** Technical Tips
If headlights or tail lights are not installed properly, condensation buildup
is possible. Please keep in mind, condensation indicates that your light assembly
does not have an airtight seal. This is even more likely when living in extreme
temperature changing climates. Any brand or even OEM replacement headlights
or tail lights are susceptible to condensation if the item is improperly installed.
Please make sure all sockets are tightly fastened and all o rings or rubber
gaskets are in good condition. Bad o rings or rubber gaskets on your factory
sockets can cause moisture. If you happen to have moisture buildup in your lights,
please try the following solution. You can simply remove your lights from the
vehicle and set out in the sun or in a dry area. Wait until the condensation
has fully evaporated, and reseal around the seams with a clear silicone sealant
on the assembly and replace any worn down o rings or rubber gaskets. This should
alleviate the condensation issue.
|