VectorNav VN-200 Surface Mount Development Kit

VN-200 SMD Development Kit

Retail: $3100.00

The VN-200 SMD Development Kit is a complete set of hardware and software designed to help you explore the device’s features and start application development quickly and easily. Kits include a VN-200 surface mount module soldered to a development board, evaluation software, GPS antenna, cables, printed manuals, and device drivers.

This development kit is for the thermal calibration: valid @ -40C to 85C.

- VN-200 chip sensor soldered to development board

- Tallyman GPS antenna with MMCX-M connector (fits VN200 rugged)

- MMCX-F to SMA-M for connecing antenna to board

- Advanced Vector Processing Engine (VPE) firmware

- 5V wall power supply

- USB and serial cables

- DIP switch "Dipstick" tool

- Extra batteries

- Printed user manuals

- Flash drive with user manuals, development libs, sample code and other support software

- Padded case

INTRODUCTION

The VN-200 is a miniature, high performance GNSS-Aided Inertial Navigation System (GNSS/INS) that combines 3-axis gyros, accelerometers and magnetometers, a high-sensitivity GNSS receiver, and advanced Kalman filtering algorithms to provide optimal estimates of position, velocity, and attitude.

0.2° Dynamic Heading Accuracy (INS)

0.03° Dynamic Pitch/Roll Accuracy (INS)

5-7°/hr Gyro In-Run Bias (typ.)

< 0.04 mg Accel In-Run Bias

±16 g Accelerometer Range

1.0m/1.5m Horizontal/Vertical Position Accuracy

±2,000˚/sec Gyroscope Range

800 Hz IMU Data

400 Hz Navigation Data

500 mW Power

For full specs see: https://www.vectornav.com/products/detail/vn-200