Replacement collar and silicone grommet for Air Hawk Tire Inflator. (AIR PUMP NOT INCLUDED)

This threaded collar is 3D printed out of ABS (Acrylonitrile Butadiene Styrene).
The silicone grommet presses into the threaded tip of the compressor & grips the brass threads of the inflator hose when it is screwed into the tip.

(The manufacturer does not sell replacement parts.)

Craftsman Grommet  &  Collar Instructions

Just so you know, the red grommet is a tight fit in the nozzle of the compressor.

The easiest way to install it is to lube the outside with one drop

dish washing soap before pressing into the nozzle.

Once installed, it will protrude by 1/8" of an inch.

Then you can screw on the red plastic collar( but do not tighten down yet).

Screw the brass threaded inflator hose into the red grommet

Lastly, tighten the red plastic collar.

The compressor is now ready to use.