3.5HP 2 Stroke Power Outboard Motor Fishing Boat Engine CDI Water Cooling System
Description
 
 
3.5HP 2-Stroke Fishing Boat Engine,Outboard Motor CDI system
 
 
attention:
 
Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10hours)
 
New but a few Scratches of outside paint ( scratches made during shipping)
Makes it looks not as Brand New
But this outboard motor engine is new!
SALE with such a very cheap price!
 
Notice: 
 
Cylinder Scoring is a serious damage,which caused by improper use and will cost you a lot of money to repair the motor.
Don't do the following will avoid cylinder Scoring:
1,start the motor on bank
2, use the motor when it stop coming out of water
Even if you want test the motor, it should be done in the river!
When there is no water coming out from the motor,please stop using it immediately ,then check the impeller of Water pump or check if the water outlet has been blocked.
 

About certification:
We can only provide CE certification, there is no other certification
can be provided,thanks for your understanding.

Overall length:83cm(32.68inch)
Overall widteh:36.5cm
Overall height:22cm
Transom height:42cm
Full throttle perating range:4000~5000rpm
Maximum output:3.5HP)
Speed:20km/h(four people)
Type:2-stroke
Ignition system:CDI system
Starting system:Manual start
Staring carburetion system:Choke start]
Propeller mark:7-1/45-A(inch)
The engine and the propeller ratio:2:1
Recommended fuel:Regular unleaded gasoline
Fuel Type:Mixed Oil (Run-in Period: 25 Gasoline: 1 2-stroke Engine Oil; after Run-in Period: 50 Gasoline: 1 2-stroke Engine Oil)
Gear ratio: 27/13

When at normal cruising,the appearence of the senveth picture. Falling back the boat, the appearence of the outboard motor likes the eighth picture . Falling back the boat, you should drive slowly otherwise the boat will not stable. The
outboard motor backet can revolve 360. Only in simple let the engine revolve 180 and the operation handle face back,the boat can fall back to drive.

Announcements
After in the sea water or turbid water cruising
1.Use the fresh water to clean the outboard motor
2.With the moderate velocity circulating the engine, cool off the water chanel with fresh water.
3.Before the cooling water completely running out, don't put the outboard motor outside. Otherwise the water will enter the air cylinder through the exhaust port, causing the engine breakdown.
4.The engine should be placed in the aridity and ventilated,avoid to be exposed directly in the sunshine.
5.Before the long term storing,you should run out of the gasoline in the fuel tank.

Please notice:
What you will receive is our new version of this boat engine The trademark will be Yadao instead of Speeda,please add pear oil to the motor and remember to replace the gear oil after the run-in period(10 hours)

Hard to start?
1.please make sure the ratio of Gasoline: Oil = Mixed Oil.Please DO use special oil for 2-stroke motor.
2.press the button on the carburetor for several times until the yellow and black pipes are full of oil.
3.leave the throttle in the start position before starting,and then keep it in the ON position after running.
 
 
NOTE:
1.About the noise: all the gasoline machines are noisy, currently we did not test the decibel , but the noise is the same as the motorcycle, so it is a normal phenomenon
2.The machine itself is lightweight, it can use on boat weight of 100kg or less , load-bearing 4 people, but the speed is certainly not the same when one person on it or 4 people on it . Customer who has high expectations on speed, please be noticed
3.It can be marched with inflatable boats, rubber boats or fishing boats
4.Necessary: you have to prepare a boat-motor stand or Hanging board on your boat
Before you use it , please add the gear oil(Please remove the cover of the gear oil box when you add gear oil), the recommended Gear oil is hypoid Gear oil SAE#90.
 
 
 
 
 
note
Our machines are all without gear oil versions. Please add gear oil to the gears before using the motor and replace gear oil after the run-in period. (If you do not know how to handle this, please contact us). Our outboard motor doesn't with oil of gear, please prepare it by yourself.
note
Our machines are all without gear oil versions. Please add gear oil to the gears before using the motor and replace gear oil after the run-in period. (If you do not know how to handle this, please contact us). Our outboard motor doesn't with oil of gear, please prepare it by yourself.
PushAuction


On Jul 12, 2024 at 02:32:32 PDT, seller added the following information:

DataCaciques