NOTE:

The tank is 10.25 inches wide distance from rear off toolbox to frame tube is 10.5″ so please check you have enough room before ordering. When fitting this tank do not tighten any of the bolts until the tank is in position, attach rear bracket loosely to the tank and place tank under frame loop, loosely attach front bracket via the air-scoop holes on the frame loop using the 2 M6 bolts, lift rear of tank and line up rear bracket with 2 forward seat catch bracket holes and fasten through the seat bracket into captive nuts on the tank rear bracket, once all bolts are in place then they can be tightened but do not over tighten as this can cause vibration, torque setting of 3.5-3.8LBS-FT should be adequate, all brackets must be attached. Although not supplied by the manufacturer we recommend the use of footboard round rubbers between brackets and frame when fitting