Notes on placing an order
1.This product is all made of 3K carbon fiber twill weave, the external 2mm epoxy resin package with adhesive backing, and can only be covered in the corresponding parts of the surface, does not belong to the molded hardware or replacement parts of the product, if you need a replacement part of the product, please contact us to customize!
2. All products are handmade by us, there may be a small number of products with inconsistent surface texture, with small white spots, or uneven edges, these are normal phenomena, if you receive a product in this case, and you can't accept these defects, please don't initiate a return request or leave negative feedback, please contact us in the first time, we can replace or refund you for free!
Installation:
Easy installed and No modification needed
1.Please clean the surface before installation.
2.Compare the position and adjust it.
3.Make sure the Temperture is not too low,if it is in Winter when you installation,please make the carbon fiber warm by Hot air blower，so it will soft and easy to be install
4.Daub adhesion promoter on the surfact to make it stick strongly.
5.Tear off the sticker and stick it.
6.Press it to make it stick strongly.
Friendly tips:
In winter or cold area, the adhesive should be slightly heated before installation. After heating, the stability will be greatly improved.
If the temperature is below 20 degrees Celsius, it is necessary to heat the adhesive.
Since there are differences between the countries and products, please measure your product’s size before place the order to avoid unnecessary in later days, thanks.