Please read entire description. No P.O. Boxes. If you’re not sure which model pump you need please message us and we can help you. Completely Refurbished Meyer E47 E-47 Snow Plow Pump. New Seal Kit including crossover seals and spring. New Ram (Ball honed cylinder). New starter motor. New A Coil. New B coil. New C coil. New B Valve. New PIN TYPE COUPLERS. New hardware kit including ground bolt and star washer. Unit was stripped, primed, painted and new decals applied. (We use pin type couplers and you must use them on your plow side or angle problems will occur. If you need a set of couplers for your plow side let us know and we will get you a set.) Pump in the picture is the actual pump you will receive. Tested THOROUGHLY under load on a test stand and adjusted. This unit works great. Some chips, scratches, runs and or flaws in the paint. Drained of oil for shipping. We recommend flushing your angle rams and using a quality low temp plow fluid such as Meyer M1. SOLD AS IS. Thank you.

Some things to remember when buying a “refurbished” or “rebuilt” pump. Avoid any pumps that only give you a vague description of what’s been done to it. (Example “any defective components replaced” know exactly what your new pump is getting) Always make sure your new pump is getting a new lift ram (any defects in a used ram will allow water in making your new pump freeze up when you need it most). I’d think twice about buying a pump that was assembled using plumbers tape to seal the joints. That stuff breaks down over time and clogs your pump up. Also make sure you’re getting new couplers, a new crossover spring and a new starter motor. Don’t put your trust in to 30 year old parts in a blizzard. Thanks for looking