No Build Time Delay on these -- They are in stock and ready to ship NOW!!! This is a brand new Black coated Ford Cleveland/Midland blockhugger header set for 1969-73 Ford Mustang and many other cars and trucks. The FC4 is a very compact design that enables Cleveland engine swaps into a variety of street rods, classic trucks, and customs ... while still working in many 351C factory-equipped Ford cars and trucks. Check out our store for the other coating options.

INSTALL NOTES:

The FC4 header features flanges for four barrel cylinder heads. If you are using two barrel cylinder heads you must also purchase our copper adapter plates, part #2BBLFC. (link below)

Comes with all hardware necessary for installation.

SPECIFICATIONS:

Engine : Ford Cleveland/Midland (351C/M-400M)
Primary Tube Diameter : 1-7/8"
Collector Diameter : 3"
Weight : 16 LBS / 7.26 KGS

FEATURES:

16-Gauge Primary and Collector Tube Thickness
3/8" Thick Flange
Patented Flange Design Requires NO Gaskets
Tightest Fitting Header Available Anywhere!
Made in the USA

INCLUDES:

Header Bolt Set
Angle Collector Reducer Set

NOTES:

The Patented Leak-Free Design that Sanderson Headers offer you is the only leak-free flange design on the market ... Do Not Attempt To Use Flange Gaskets! The raised flange on the Sanderson Headers will buckle the gasket during tightening and actually cause a leak!

Sanderson Headers are NOT emissions legal on pollution-controlled motor vehicles. It is the purchaser's responsibility to verify local regulations for compliance.

Wrapping your Sanderson Headers with ANY thermal tape voids your header warranty. The best thermal protection for your headers is our Aluminized Ceramic Coating that is available for every Sanderson Header.

WARRANTY:

Limited 5-Year Warranty

DIMENSIONS:

When sitting in driver's seat and engine in front of you, the LEFT header would be the Driver's Side on LH drive vehicles; coincidently, means the RIGHT header is on the passenger side. See the detail image that describes engine sides.