Centrifugal clutch for 3/4" shaft engine with upgraded mounting hardware.

Shaft size: 3/4" Bore
Chain Size: #35 Chain
Tooth Count: 12 Tooth
Engagement is Approximately: 1800-2200 RPMs

Replace your worn out clutch with this affordable item. Can be mounted inboard or outboard. Has key stock. Comes with upgraded mounting hardware - no need to use set screws.
Fits the following motors and many others:
Honda GX160 Honda GX200
Harbor Freight Greyhound 196cc
Harbor Freight Predator 212cc
Nearly all 5.5 HP clones Nearly all 6.5 HP clones
Nearly all 4-7HP motors, all brands.
PLEASE MEASURE YOUR CRANKSHAFT TO BE SURE!
Know your gear ratio! An
Responsive image

3/4" Clutch for #35 Chain with Hardware

Centrifugal clutch for 3/4" shaft engine with upgraded mounting hardware.

  • Shaft size: 3/4" Bore
  • Chain Size: #35 Chain
  • Tooth Count: 12 Tooth
  • Engagement is Approximately: 1800-2200 RPMs

Replace your worn out clutch with this affordable item. Can be mounted inboard or outboard. Has key stock. Comes with upgraded mounting hardware - no need to use set screws.

Fits the following motors and many others:

Honda GX160 Honda GX200

Harbor Freight Greyhound 196cc

Harbor Freight Predator 212cc

Nearly all 5.5 HP clones Nearly all 6.5 HP clones

Nearly all 4-7HP motors, all brands.

PLEASE MEASURE YOUR CRANKSHAFT TO BE SURE!

Know your gear ratio! An acceptable gear ratio for a 12T #35 clutch would be a 60T or larger rear sprocket. A 10T #41 clutch would need a 50T or larger rear sprocket. Vehicles with rims larger than 6" or tires with a diameter of 15" or larger should upgrade to a belt drive TAV system. Gear ratios outside of these recommendations voids any warranty.



We do not accept returns on any electrical components.