Two (2) Evinrude 2011 Model Year 200HP HO 3.3L 90-degree V6 ETEC (counter-rotating pair), 25-inch shaft, ICON electronic throttle and shift Evinrude Outboards for sale.  Pickup in Massachusetts only.  Cannot ship. The engines are being sold as a pair, not individually. Both engines have been stored indoors on boat during off season since 2012.

 

This ad is for two (2) engines, one (1), righthand rotation, one (1) counter rotation currently on a boat that is in service on Cape Cod.  There are many new parts on both engines, including the engine block, as well as much of the rotating assemblies.  Some of the new items are listed below.  Port engine rotating assembly hours: 90 hours.  Starboard engine rotating assembly: 50 hours.  Entire internal mid-section on both engines: 150 hours.  Diagnostic reports available upon request.

 

The engines are on a boat so that a prospective buyer can observe the engine operating and perform any inspection necessary. These engines are being sold as a pair in as is condition because new engines are being installed on boat when these engines sell. Both engines run well, have smooth idle, no issues, and have been flushed with fresh water through engine after every use. Compression test results: Port engine, cylinders 1, 3, 5, 2, 4, 6: 128psi, 128psi, 128psi, 128psi, 125psi, 123psi.  Starboard engine, cylinders 1, 3, 5, 2, 4, 6: 128psi, 128psi, 130psi, 122psi, 127psi, 125psi.  For sale without propellers, without controls, without wiring harness, without oil tank, without warranty, and without gauges. Dual binnacle ICON electronic control box, wiring harness, and 3-gallon oil tanks available for $900.

 

Service performed every year on both engines utilizes all OEM Evinrude replacement parts/supplies: fuel filter, spark plugs, thermostats, blowoff valve, gear oil, anodes.  Other annual service performed each year: throttle calibration, shift calibration, air intake silencer cleaning, grease all lubrication points, compression check each cylinder, fuel pump return filter screen.  Service performed every other year utilizes all OEM Evinrude replacement parts/supplies: water pump, lower unit upper driveshaft seal, shift shaft seal, prop shaft seals, bearing carrier seals, lower unit anode.

 

Partial list of new OEM Evinrude replacement parts installed on port engine within the past 18 months: factory fresh cylinder block, crankshaft, pistons, rings, stator assembly, starter, engine management module, all fuel injectors rebuilt, supply and return fuel manifold lines, all oil injection lines replaced, all oil circulation lines + check valves replaced, water pump, fuel filter, oil filter, spark plugs, thermostats, blowoff valve, stator, mid-section exhaust plenum, mid-section exhaust plenum seals, mid-section water inlet tube, air intake silencer.

 

Partial list of new OEM Evinrude replacement parts installed on starboard engine within the past 18 months: pistons, rings, stator assembly, all fuel injectors rebuilt, #6 injector replaced, supply and return fuel manifold lines, all oil injection lines replaced, all oil circulation lines + check valves replaced, water pump, fuel filter, oil filter, spark plugs, thermostats, blowoff valve, stator, mid-section exhaust plenum, mid-section exhaust plenum seals, mid-section water inlet tube, air intake silencer.