BRAND NEW 3 PCS REAL CARBON FIBER Silver GEL COATED TRIM KIT FOR Water cup Decoration Trim.

FEATURES..

1. GLOSSY GEL COATED FINISH.

2. REAL CARBON FIBER MATERIAL.

3. BACKING ADHESIVE.

4. PROVIDE SUPER CAR INTERIOR LOOK.

IMPORTANT PLEASE NOTE..

1. ONLY USE CLEAN WARM HOT WATER TO CLEAN THE SURFACE WHERE THESE TRIMS ARE GOING TO STICK ON.

2. THEN USE ALCOHOL TO REMOVE ALL POSSIBLE WAX CLEAR PRODUCT LEFT ON PLASTIC, THEN WIPE OFF WITH DRY CLEAN MICROFIBER TOWER. THIS IS ENSURE BACKING TO DO ITS MAXIMUM JOB.  

3. BEST TO USE HAIRDRYER TO WARM UP ADHESIVE AFTER PEEL. THEN CAREFULLY STICK ON PLASTIC. AVOID TOUCH ADHESIVE DURING INSTALLATION FOR BEST RESULT. 

4. LET SIT AT LEAST 24 HOURS FOR ADHESIVE TO REACH MAXIMUM STRENGTH.

1. Avoid bending when clear coat is hard due to cold climate maybe result crack.

2. Product required to be heated until flexible before install. Best is to place in the sun for about 3-5 mins till flexible and heated evenly. Or use dryer to make it flexible enough to fit the interior contour.

3. Clean interior surface few times with tooth brush and hot water ensure wax removal for better sticking surface, then wipe / dryer til fully dry before sticking.

4. Press and hold firmly few mins. Check in the few days after installed maintain press hold if come loose due to climate temperature.

**5. European cars interior have environmental friendly coating will preventing double side from sticking. this may required to use epoxy glue to secure in place.