One (1) Evinrude 2011 Model Year 200HP HO 3.3L 90-degree V6 ETEC 25-inch shaft, righthand rotation, ICON electronic throttle and shift outboard for sale. Pickup in Massachusetts only. The engine has been stored indoors on boat during off season since 2012.
The engine is currently on a boat that is in service on Cape Cod. There are many new parts on this engine including much of the rotating assembly which has 50 running hours. The entire internal mid-section has 150 hours. Diagnostic report available upon request.
The engine is on a boat so that a prospective buyer can observe the engine operating and perform any inspection necessary. This engine is being sold in as is condition because a new engine is being installed on boat when this engine sells. The engine run well, has smooth idle, no issues, and has been flushed with fresh water through engine after every use. Compression test results: cylinders 1, 3, 5, 2, 4, 6: 128psi, 128psi, 130psi, 122psi, 127psi, 125psi. For sale without propeller, without controls, without wiring harness, without oil tank, without warranty, and without gauges. Wiring harness, and 3-gallon oil tank available for $200.
Service performed every year utilizes all OEM Evinrude replacement parts/supplies: fuel filter, spark plugs, thermostats, blowoff valve, gear oil, anodes. Other annual service performed each year: throttle calibration, shift calibration, air intake silencer cleaning, grease all lubrication points, compression check each cylinder, fuel pump return filter screen. Service performed every other year utilizes all OEM Evinrude replacement parts/supplies: water pump, lower unit upper driveshaft seal, shift shaft seal, prop shaft seals, bearing carrier seals, lower unit anode.
Partial list of new OEM Evinrude replacement parts installed within the past 18 months: pistons, rings, stator assembly, all fuel injectors rebuilt, #6 injector replaced, supply and return fuel manifold lines, all oil injection lines replaced, all oil circulation lines + check valves replaced, water pump, water pressure sensor, fuel filter, oil filter, spark plugs, thermostats, blowoff valve, mid-section exhaust plenum, mid-section exhaust plenum seals, mid-section water inlet tube, air intake silencer.