|
Installation Instruction: Bucket Seats 1. Remove headrests for easy access. 2. Push the Seat forward. 3. Slide the seat cover over the top of the seat until it you reach the bottom of the chair. 4. Locate the "insert tap" located in the middle of the cover and slip it through the gap between the seat where the back and bottom part meet. From the rear side of the seat pull the slipped through tap until the cover is set in position. Fit base of cover snugly over seat. 5. Fasten the elastic clips at the end of the seat covers with supplied "S" hooks and connect them to the elastic on the opposite side or anything the hook can be connecting to under to seat. 6. For armrests (seat covers that does not contain the opening on the side), use a razor or a sharp instrument to create a small hole on the seat cover and slip the armrest through. 7. Re-insert the headrest into your seat. 8. Place on head rest cover. Bench Seats 1. If possible, remove bench seat from vehicle for easier access. 2. Remove headrests for easy access. 3. Push the Seat forward. 4. Slide the seat cover over the top of the seat until it you reach the bottom of the chair. 5. Note: It rarely occurs where the bench seat belts are a part of the chair and also inhibit the usage of the seat covers. If so, you will need to temporarily detach the seat belts. Consult your vehicle’s manufacturer manual for further information. 6. If desired, you may fasten the elastic clips at the end of the seat covers with supplied "S" hooks. 7. Re-insert the headrest into your seat. 9. Place on head rest cover. Steering wheel Cover: Please note the steering wheel cover were intentionally made smaller in order to prevent from shifting after it's installed therefor it might require quite a bit of force to install it. You may place it under the direct sun light for 20 minutes or use the hair dryer to carefully heat it up a bit for an easier installation. Once it's ready to be install start from the top end and generally twist and pull it down toward the bottom part. |