Holley Rebuilder Carb Kit For 780 CFM Spread Bore With Vacuum Secondary's & Vent Valve Seal. 

These new gaskets fit 4160 series 780 CFM Holley 4 barrel carbs with vacuum secondary's, 1-1/2" primary and 1-3/4" secondary throttle bores and no removable jets in the secondary's. This carb is a spread bore with square flange bolt pattern. List # 7010 only. 

This Rebuilder Carb Kit Is Ethanol Tolerant.

Please include list number of carb when ordering a kit.

NOTE: THIS KIT WILL ONLY REBUILD CARBS WITH EXTERNALLY ADJUSTABLE FLOATS.

Kit does not include instructions.

This kit contains the following parts

• 1 Gray Fiber Intake Flange Gasket
• 1 Gray Fiber Throttle Body Gasket
• 1 Black Non Stick Metering Block Gasket
• 1 Black Non Stick Fuel Bowl Gasket
• 2 Black Non Stick Metering Plate Gaskets
• 1 Two Window Power Value & P/V Gasket
• 1 Accelerator Pump Diaphragm 30cc
• 1 Red Umbrella Accelerator Pump Check Valve
• 2 Viton 0.110" Needle & Seats With Gaskets
• 1 Vacuum Secondary Diaphragm
• 2 Fuel Inlet Gaskets
• 8 Nylon Fuel Bowl Screw Gaskets
• 1 Vacuum Housing Cork Gasket
• 1 Choke Housing Cork Gasket
• 2 Fuel Bowl Sight Plug Gaskets
• 1 Primary Fuel Bowl Vent Valve Seal
• 2 Accelerator Pump Transfer Tube O Rings
• 2 Cork Idle Screw Gaskets
• 2 Nozzle/Shooter Gaskets
• 1 Float Bowl Vent Valve
• 1 Accelerator Pump Rod E Clip
• 1 Vacuum Rod E Clip
• 1 Secondary Return Link Cotter Pin
• 1 Choke Link Hitch Pin
• 1 Choke Thermostat Gasket
• 1 Choke Housing Gasket
• 1 Gray Fiber Air Cleaner Flange Gasket

PLEASE INCLUDE LIST NUMBER OF CARB WHEN ORDERING A KIT.

Contact me if you have any questions about fitment.

All Canadian purchases will be shipped from Canada.