Falcon Racing Transmission with Free Stand
The Falcon Late Model transmission has two forward speeds, neutral, and reverse, with an integral hydraulically-applied clutch operating low and reverse gears. High gear is a direct-drive 1-to-1 ratio with minimal rotating mass. With its aluminum case and extension housing, the transmission weighs just 45 pounds.
It’s comparable dimensionally to a Muncie, T-10, and other similar transmissions—and that includes the 1-3/16” x 27-spline output shaft, which by design contributes to the most positive high gear retention in the industry. It comes with the correct crank coupler for easy installation—even to a stock flywheel housing. Frictionless bearings support all rotating components for unmatched durability, and as with all Winters transmissions, all rotating internals, from gears to shafts, are REM-finished.
- IMCA Approved for Stock Car, Modified, and Late Model classes
- Includes Chevy Late Small Block (1986-Up 1-Piece Rear Main) 18 Spline Crank Coupler (Winters 8251-62350-18)
- Internal wet clutch saves the cost and rotating mass of a "stock" type clutch, no torque converter or pressure plate required.
- Hydraulic clutch pedal required
- All rotating internals, from gears to shafts, are REM-finished
- Strong enough to hold up through the low-900 HP range
- Extension Housing includes a sturdy roller bearing to accommodate 1-1/2 inch diameter slip yokes
- 9 inch yoke permits 7-1/2" of yoke travel while maintaining a minimum of 1-1/2" of spline engagement
- Measure 21-5/8" from bellhousing flange to end of tail housing
- 1-3/16 x 27 spline output shaft
- Two forward speeds
Very pleased this transmission it's exactly as advertised
Summary: Used in 602 crate late. No complaints. Speedway Motors made ordering easy and had it in 3 days. I recommend this transmission.
Pros: Fit well with falcon bellhousing. Works perfect.
Yes, I recommend this product.
