Application: USE THE INSTRUCTIONS IN THE KIT

Pieces in  Kit: 28

*NOTE: This Kit is For a Left Drive Car/Truck Only.

*NOTE: Please View The Ad Carefully to Ensure This Applications will Fit Your Specfic Trim Level.

INSTALLATION INSTRUCTIONS:

TOOLS REQUIRED, Utility Knife, Paper Towels, Cotton Swabs, Hair Dryer, Rubber Gloves

Ideal Installation Temperature: 70-85F

Helpful Tips:

1) Dry Fit all Components In Order to Get a Visual Perspective on Part Placement Before Installation

2) Install Smallest Components First in Order To Get Familiar Before Attempting Larger More Difficult Pieces.

These are Heritage Dash Kits, Made by Sherwood Innovations Trim. Precision Laser Cut, Easy to Install, With Step Step Instructions Listed Below.  We make our kits from Simulated Materials.

We Have a Large Amount of Pictures on File But Do Not Have All the Correct Interior Shots of the Product Installed. You Will See the Parts Kit Opened and a Shot of the Actual Kit that is Shipped.

If The Kits Have Been Install They ARE NOT RETURNABLE.

Preparation & Cleaning:

Using Isopropyl Alcohol, Thoroughly Clean the Surface Areas That are to Be Covered by The Dash Components. The Dash Should Be Free of Lint or Contaminants Before Installation. Used Or Pre-Owned Vehicles that Have Had Silicon Based Vinyl Treatments such as "Armour-All" or "Formula 2000" Need Special Care. The Adhesive Will Not Stick to Any Surface That has Any of the Residue Remaining. In These Cases, a Stronger Cleaner May Be Necessary. If the Dash is Dull in Appearance, And You Know Silicon Residue Can Be Felt on Your Fingers, The Dash Should be Fine. You Can Test the Surface Using Masking Tape to See if It Adheres.

Applying the Adhesive Promoter:

Open The Packet of Adhesive Promoter in a Dish. Dip a Cotton Swab Into the Adhesive Promoter and Carefully Apply the Product Only to the Surface Area that Are to Covered by the Trim Pieces.

WARNING Adhesive Promoter is Highly Corrosive and Will Permanently Discolor any Part of the Vehicle That it Comes In Contact With. We Highly Recommend the Use of Rubber Gloves When Applying the Product to Protect Your Skin. Please Use Only in a Well Ventilated Area To Avoid Inhaling the Fumes.

An Adhesive Promoter Pen is Available at a Extra Charge from the Manufactures. Each Pen Lasts for 5-10 Dash Installations.

Now You are Ready to Apply the Interior Package. First Using Your Utility Knife Catch the Corner of the Red Liner of the 3M Adhesive and Remove It. Be Careful to Avoid Making Contact With the Adhesive Surface so as Not to Contaminate the Tape. Once The Liner is Removed, Carefully Install the Part "Left To Right" in Order To Avoid Center Buckling. Once The Part is in Place, Gently Press Down With Your Fingers to Ensure that the Product has Made Good Contact. In Bending Situations or In Cold Climate Installations, Use the Hair Dryer to Soften the Parts Before Bending. It Will Not Only Avoid Breakage, But Will Make the Tape More "Tacky" for a Better Contact.

WARNING: The 3M 4229P Tape Fully Cures over a 72 Hour Period. Please Avoid Tampering with the Kit During This Time. If You See a Piece Lifting, Gently Press it Down Into Place.

Cleaning and Care:

Clean Your Dash Kit Using Water or Window Cleaner. Avoid Using Vinyl Treatments That May Effect Adhesion Over Time.