Up for sale is a complete High flow tpi intake setup.  As is It can be ran as mass air no cold start. Or it can be ran as speed density.  You can spend more money on a unported setup with aftermarket parts that will not flow as good as this one.

Just for a edelbrock lower intake and runners is $850 here on ebay. I am selling a complete intake setup for less than that.

Ready to ship as pictured plus fuel rail. If you want everything polished except for the lower intake and steel parts? That is $300 over they buy it now. I can change the auction to include polishing if you want. But I am Very Busy in the shop. So there would be  a 2 to 3  week delay on shipping to polish everything. If you need it now please don't ask for the polishing.  The last picture is to give you an idea of what it can look like polished.

Don't miss out on this High flow setup. It is actually a high flow setup. You can add all the aftermarket parts you want. But if the plenum is not ported the aftermarket parts do no good.

I have shipping set at $70. If it cost more I will cover it. If it is less I will refund the difference.

Save big on this complete High Flow setup. 

Here are a few things  we do that the other guy don't. Top quality Porting, stock runner porting and runner enlargement,  fuel rail rebuilding and rear feed modification, throttle body rebuilding, properly mask off all gasket surfaces before powder coating, Powder coat ALL the steel parts. So you don't end up with a polished setup with rusty parts. Tap and clean all bolt holes, Powder coat inside the grooves on top of the plenum. All the other guys don't do anything inside the grooves.

Includes.

1, Very nice Used  Edelbrock High Flow 3860 lower intake. It has the dual bolt pattern. It will bolt to any sbc head 55/92. It will not bolt to Vortec heads that do not have the four center bolt holes. It is powder coated silver. Someone ground off the edelbrock high flow on the top. It still has the 3860 on the bottom.  $470 value.

2, Rebuilt Fuel rail, 89/81 Corvette. 89/92 Camaro, firebird or modified for rear feed.  It has new orings and  good Holley adjustable regulator installed. With powder coated lines and hardware.  $175 value.

3, Used 89/92 SLP Runners. They do have a few scuffs. Look at the pictures. $300 value.

4, 89/92 Ported plenum. The throttle openings are ported to 58mm. The runner openings are ported and siamesed.  $175.00 value.

5, New Professional products Satin 52mm Throttle body. $225 value.

6, New Aluminum plenum extention. $50 value.

7, Stainless bolt kit. $40 value.

8, Lokar or standard OEM Throttle cable bracket. $30 to $60 value.

9.Used  Powder coated thermostat housing. $30 value.

Any questioons ask. 

Check out my other items!

Thank you!!

Isaac