This item is new – it will work once programmed to your vehicle
One (1)
O.E.M. Original Equipment Manufacturer Factory
remote keyless entry fob alarm
Transmitter control clicker keyfob controller replacement
Functions at 100% Tested & Guaranteed
| Item #: | 94 A - C NEW |
|---|---|
| FCC ID: | OUC60270 |
| Part #: | GM15912860, GM15859331, GM10337867, GM20833562 (15912860, 15859331, 10337867, 20833562) |
| NOTE: | AutoStart Remote Starter |
BEFORE YOU BUY PLEASE READ.…
This is a NEW factory Original Equipment
O.E.M. keyless remote control transmitter
Remote / Battery Specifications
Condition:
NEW
Battery:
Yes, Installed
Buttons:
5: Auto Start, Lock, Unlock, Trunk Release, Panic Button
Required Batteries:
1: CR2032
Frequency:
315MHz (315 MHz)
Compatible Vehicles*:
2006 2007 2008 2009 2010 2011 Chevrolet Impala
2006 2007 2008 2009 Chevrolet Monte Carlo
2006 2007 Cadillac DTS
2006 2007 2008 2009 2010 2011 Buick Lucerne
*All vehicles with factory installed Remote Keyless Entry (RKE).
|
MAKE/MODEL |
YEARS |
|
BUICK LUCERNE Use this Procedure for Vehicles with 1. Insert Key and turn to ON position so you can access Driver Information Center 6. To exit programming mode turn key off and remove key. Test remote(s).
To
access this display, the vehicle must be in Park (P) with key in the on
position (as far as you can go without cranking engine) 2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display 3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed. 4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed. 5. To exit programming mode turn key off and remove key. Test remote(s). |
2006 2007 2008 2009 2010 2011 06 07 08 09 10 11 All Models With Keyless Entry |
|
CADILLAC DTS Use this Procedure for Vehicles with 1. Insert Key and turn to ON position so you can access Driver Information Center 6. To exit programming mode turn key off and remove key. Test remote(s).
To
access this display, the vehicle must be in Park (P) with key in the on
position (as far as you can go without cranking engine) 2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display 3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed. 4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed. 5. To exit programming mode turnkey off and remove key. Test remote(s).
|
2006 2007 06 07 All Models With Keyless Entry |
|
CHEVY IMPALA Use this Procedure for Vehicles with 1. Insert Key and turn to ON position so you can access Driver Information Center 6. To exit programming mode turn key off and remove key. Test remote(s).
To
access this display, the vehicle must be in Park (P) with key in the on
position (as far as you can go without cranking engine) 2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display 3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is 4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed. 5. To exit programming mode turn key off and remove key. Test remote(s). |
2006 2007 2008 2009 2010 2011 06 07 08 09 10 11 All Models With Keyless Entry |
|
CHEVY MONTE CARLO Use this Procedure for Vehicles with 1. Insert Key and turn to ON position so you can access Driver Information Center 6. To exit programming mode turn key off and remove key. Test remote(s).
To
access this display, the vehicle must be in Park (P) with key in the on
position (as far as you can go without cranking engine) 2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display 3. Press and hold the lock and unlock buttons on the first keyless remote at the same time for approximately 15 seconds. A chime will sound indicating that the remote is programmed. 4. To program additional remotes at this time repeat step 3. This vehicle can have a maximum of eight remotes programmed. 5. To exit programming mode turn key off and remove key. Test remote(s). |
2006 2007 2008 2009 06 07 08 09 All Models With Keyless Entry |
All of our keyless remotes are listed just as the manufacturer states for make model & year compatibility
SOME VEHICLES HAVE KEYLESS SYSTEMS INSTALLED THAT HAVE STANDARD PACKAGES & SOME ARE OPTIONAL (DEALER INSTALLED)
(this can change what remote FCC ID &/or part will be compatible with your system)
WE ASK THAT YOU VERIFY w/ A DEALER PRIOR TO PURCHASE AS TO WHAT FCC ID # YOU NEED FOR YOUR VIN
STOP!
Before You Buy Please Read…
Program Remote To Your Vehicle
If you're not sure your vehicle can use this remote, please ask questions or contact your local dealer first.
This remote needs to be programmed to your vehicle in order for it to work with your vehicle’s installed RKE (remote keyless entry ) system:
1. Some years require diagnostic programming according to how the manufacturer set the system
a. Free programming Requirements per manufacturer upon request
b. Contact us via eBay messages (Keyless4u store) Prior to Purchase
with your vehicle’s ….
1. Make
2. Model
3. Year
2. We will respond via eBay messages with the manufacturer’s programming requirements so that you can determine if you are capable of programming your vehicle or if you will need to visit a local dealer or locksmith for programming with a diagnostic scan tool – we do not write the programming – we pass it on to you as a courtesy.
How to find out if this remote is compatible with your Vehicles’ installed RKE System
If you're not sure your vehicle can use this remote, please ask questions or contact your local dealer first.
1. Check the back of your current or old keyless remote to match FCC ID /Part #’s.
2. Contact your local dealer and tell them your VIN# and ask what part # / FCC ID you need.
Your vehicle will be installed with one of the following keyless entry systems:
a. Standard Keyless Remote Packages: Installed at time of manufacture.
b. Optional Keyless Remote Packages: Installed by a dealer.
c. Aftermarket Keyless Remote Packages: Installed by previous owner or a car/audio shop.
d. No remote keyless entry system at all.
The above
information can change which remote you need
for your installed remote keyless system.
Australian Customers: The frequency of our remotes typically do not match the frequency needed for Australian Model Remotes. Please verify that this remote will work for your vehicle prior to purchase.
Payment: We accept payment via PayPal or Credit Card. Please contact us via eBay messages for any questions concerning payments. Payment is expected within 5 days
PA SALES TAX: As per the State of PA Franchise Board we must collect sales tax from PA Residents for any purchase made from our store.
Contact/Email: Due to scams etc, we DO NOT respond to emails. We only read/respond to EBAY MESSAGES. Messages & Best Offers are checked throughout the day & we typically respond 7 days a week. Please contact us with questions via eBay messages (keyless4u).
100% Guarantee Remote Shipping / Return Policy
Shipping & Handling
Combined Shipping & Handling Discount (multiple item purchase discount):
S&H discount = the price of the 1ST remote’s S&H + 1.99 each additional remote’s S&H
Shipped From: Pennsylvania, USA
Shipping Method: USPS mail service
USA Shipment Options:
◊ USPS 1ST class mail service
◊ USPS Priority class mail service
◊ USPS EXPRESS class mail service
Canadian Shipment Options:
◊ USPS 1ST class mail service
◊ USPS Priority class mail service
◊ USPS Express class mail service
Worldwide (Outside of USA & Canada) Shipment Options:
◊ USPS Priority class mail service
◊ USPS Express class mail service
Australian Customers: The frequency of our remotes typically do not match the frequency needed for Australian Model Remotes. Please verify that this remote will work for your vehicle prior to purchase.
Warranty/Returns:
1. We have a 30 day return policy.
2. All returns for replacements and refund need an RMA #.
3. Please contact us before returning items so we can give you the RMA # and the proper return address.
4. No refunds / replacements will be granted without an RMA#
We ensure proper working condition of all previously used or new remotes through a serious of tests performed with the Santronics Testing device. Each button is tested for functionality prior to shipment and then logged.
Please Note: Each remote and circuit board is UV id’d prior to shipment – All returns receive a UV ID inspection to verify originality of remote sent prior to refund or replacement.
Does this keyless remote entry come with a battery?
Yes. It will have a working battery installed.
Battery Condition:
A. All remotes sold on Keyless4u include working batteries.
B. Installed batteries are not tested for battery life- they are simply working.
Some are new and some are used.
WORD KEY:
- Keyless Remote Entry = Vehicle Lock / Unlock Remote Control
- RKE = Remote Keyless Entry
- Keyfob or Key Fob = Keyless Remote Transmitter Control
- Clicker = Keyless Remote Entry Control
- VIN # = Vehicle Identification #: 17 characters
- OEM = Original Equipment Manufacturer