Before bidding ,please confirm your car can use this cd changer !!!! |
IF Possible please send the picture of your car's headunit (front and back),we will confirm it for you ! |
Descriptions
|
| |
| |
| |
-
Introduction:
This is a Audio car kit. It is a replacement of CD changer. It can be easily installed and used. The installation and usage are the same as CD changer's installation and usage, Simply plug in USB disk/SD card, you can play audio through car audio system and enjoy music in your car.
After conneted with optional Bluetooth module kit (Bluetooth module need add extra cost), it integrates bluetooth hands free phone call and stream mobile phone's A2DP music playback into car stereo system.
1.Voltage input:12v DC
2.Signal-to-noise:95DB
3.Max.Current:600MA
4.Max. voltage output:12v
5.D/A Device :24BIT 192KHZ
6.Total Harmonic Distortion:0.01%
7.Frequency Response:20HZ-20KHZ
8.Working Temperature:-10C-80C
9.Module case in made of aluminium alloy
.
-
1. Plug&play, modular design,CDC alternative
2. Connected with wire harness, not FM signal controlled ,Hi-Fi guanranteed
3. Controlled by vehicle Head Unit,support Steering wheel operation
4. With Hi-Fi Decoding Chip,perfectly support MP3 and WMA tracks
5. Supports SD/SDHC/MMC card/U Disk/Card Reader/Hard Disk
6. Supports external audio source(MP4 PSP Mobile Phone) via AUX in port
7. Playlist function same as multi CDs
8. Supports Last Position Memory(LPM)
9. Vibration and interference proof
10. Easy to install,no damage to original car decoration
11. Different module firmware versions for different types of protocol of car stereos
12. With BT slot for additional Bluetooth hands-free kit(YT-BTM).
.
.
-
Application
-
Item No. |
YT-M06 MAZDA |
Includes:
1 X Module unit for Mazda
1 XMazda plug
1 X AUX cable
|
Compatible Models |
Mazda
(Without navigation) |
2005-2008 Mazda 2, 2004-2008 Mazda 3 , 2006-2009 Mazda 5(without entertainment system) , 2006-2008 Mazda 6 (see note 3), 2003-2008 Miata/MX5(note 2) , 2002-2006 SPD, 2002-2003 Protégé, 2007-2008 CX7 ,2004-2008 RX8(see note 4) , 2002-2006 Tribute,
2002->2008 Premacy,1999-2003 Mazda 323 , 2002-2011 MPV ,2003-2006 B-Series Pickup, |
| FORD |
FORD Ranger(not USB version)2008-2011 with radio CQ-8670TA (panasionc) |
Compatibility Head units |
1168, 1269, 4103, 14789909, 14792086,14792089, 14794008, 14794522, 14795137, CQ-EM4570AK, CQ-LM4720A, CQ-TT3070AA, CR-LM4282KA, CR-LM4282KA CD, CQ-XM8950A, GS1F669RXA, GJ6R66DSXF02, PT-2674J, etc |
Compatibility notice |
1:Not compatible with Satellite/Navigation radios.
2: Not all Mazda 6 supports external CDC connection, internal modification might be needed; Mazda 6, produced from Nov. 2003 to Sep. 2005, needs to solder a jumper or a 0-ohm chip register on location L716 in its head unit.
3: RX-8 radio firmware version must be v9.55 or later, v10.1 and v9.81 not supported.
|
1. Max 32GB(4-8GB is most recommended), SD card is more recommended than USB sticks
2. Please format SD card or USB sticks with FAT16/ FAT32 before you save files or folder in USB/SD card.
3. Impose folder naming system :CD01,CD02,CD03……Doesn’t read sub-folder and gets confused with other name in root of the drive
4. Supports up 99 folders (depending on the radio type) on you USB/SD
5. Any number of songs can be stored in each folder, but the display of most radio models can only screen 99 tracks titles; Saving too big file (over 50M)in any folder may also cause intermittent performance.
6. Using music file formats other than WMA or MP3 may also cause intermittent performance
7. The playback order of songs is in line with other created date.
8. Sometimes, to remove defect on software of car audio system ,you may need to disconnect the battery or remove the fuse to reset the car audio system.
9. To use the AUX-In port, it’s necessary to remove the USB or SD card.
10. YT-M06 may does not work with some of new Kingston brand USB stick.
-
Installation Steps
1. Before installation, switch off the electric power, take out the Head Unit, and find CD Changer port at the back of the Head Unit.
2. Properly connect the wire harness between the product and the Head Unit.
3. Switch on the electric power, insert MP3/WMA storage device and run the Head Unit, check whether the product works normally.
4. After the successful test, fix the Head Unit in the original place, and put the wire harness in proper place. Then installation is completed.
.
-
Important Installation Information:
Your car head unit should be CD changer capable. This device is applied to orignal car audio equiptment or upgraded car audio equiptment with supporting digital music changer ports only , furthermore , same brand car with different model should use individual digital music changer . Each car use specific device . More options coming soon available for your choice .The in-dash CD changer will remain working, but external CD changer are switchable by a switch on the wire harness.
If your car isn't listed here, we also have a large stock of iPod adapters for many other vehicles.
Please send us a message stating your requirement and we'll do our best to assist.
If you are unsure as to whether this adapter is suitable for your vehicle, please feel free to ask before purchasing.
.
- Warranty and Guarantee:
1.All the products have been tested in good working before ship.
2.If you are not satisfied when you receive your item, please return it within 7 days for a replacement or money back. The buyer are responsible for the shipping cost.
3.If item defective in 1 month, We will send you a replacement without extra charger, or offer refund after we receive the defective item.
|
|
