Find or Sell any Parts for Your Vehicle in USA

Gm 22009038 Pulsair Air Valve 4 Tube Pipe 2.5l 80-85 Skylark Citation on 2040-parts.com

US $49.99
Location:

NC, United States

NC, United States
Condition:New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions Brand:Genral Motors Manufacturer Part Number:22009038 Superseded Part Number:22050646 UPC:Does not apply

Honda plans gasoline engine for the CR-Z

Tue, 07 Dec 2010

Honda is set to provide the CR-Z with an all-new four-cylinder gasoline-engine option as part of plans to broaden the compact coupe's appeal in key world markets, including North America. Currently available with just one engine option—a gasoline-electric hybrid system that mates a 1.5-liter four-cylinder engine with a brushless electric motor—the CR-Z is also earmarked to receive a turbocharged 1.6-liter four-cylinder engine currently undergoing development in Japan. The new unit, which is also planned for the Jazz, the Civic and the Accord, forms an integral part of an engine downsizing program instigated at Honda.

Was the Corvette museum collapse a hoax?

Tue, 11 Mar 2014

When you saw video footage of eight Corvettes falling through the floor of the National Corvette Museum in Bowling Green, Ky. , did you think it looked a little …off? When you saw the photos in the New York Times, did you start to suspect that perhaps the Illuminati had something to do with it?

Nissan Juke-R is prepared for its heart transplant: Video

Wed, 19 Oct 2011

Nissan, in its quest to make the craziest compact car in the world, has released another video of the Nissan GT-R-to-Juke engine transplant. The video shows some of the frame cutting that needed to be done to fit the twin-turbocharged V6 into the Juke small crossover, along with the roll cage being welded in. Jigs are also attached to keep the frame straight while the work is going on.